0 votes
6k views

My vent microwave exhaust fan does not work on the low speed but works fine on the high speed.
I have tried unplugging, waiting and plugging back in with no effect.
All other buttons on the touch pad seem to work just fine.
Any diagnosis tips or is there an obvious solution?

  • scott asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Our oven worked perfectly through Thanksgiving (thank goodness!) but last night I’m pretty sure it didn’t heat up to the preheat temp even though it said it had and beeped as if ready. Dinner took much longer than normal to cook and I’m wondering if something isn’t right. I’m going to have my boyfriend take a look at it if someone could point me in the right direction on what to check?

  • Amanda asked 9 years ago
  • last active 9 years ago
0 votes
2k views

I have so much laundry to do and need this taken care of. I had my husband check the fuse and thermostat after seeing another question similar to mine. If I can get the correct part I think I can handle fixing it myself. Thanks!

  • Laureen asked 9 years ago
  • last active 9 years ago
0 votes
2k views

Timer on dishwasher stops when the dial pointer is at 180 degrees.
Manually move it past that point and the cycle will continue until finished. I installed a new timer but the DW is acting the same way.
Any suggestions on what I should do nest will be appreciated. Thank you.

0 votes
2k views

I went to service a Frigidaire Infinity washer today, I cannot get the unit to go
Into the Diagnostic mode, Only two lights on the Console will light up. I replace the Control
Module and still get the same results, need some Help or direction..

0 votes
2k views

My Frigidaire dryer will not start.

0 votes
2k views

The touchpad buttons on my Frigidaire stove are unresponsive.

0 votes
2k views

My Frigidaire refrigerator is not making ice.

0 votes
2k views

the compressor will kick on and then go out rite away .
then a few minutes later it will do the same

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
2k views

Can you tell me what could be causing this issue on a Frigidaire Freezer? It is having these problems: Not cooling

0 votes
2k views

When I press the lever for the ice dispenser it doesn’t dispense ice. No sound or movement. I can hear the micro switch.

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views
i30

the pump keeps running and im getting i30 tried resetting but i did not help

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

At start of cycle door locks then pauses . at times it won’t release. I cannot get the service test to activate. Which is the left button under the display? There instructions are very confusing. I have the tech sheet but a service manual may help. Any videos on this would help especially on the diagnostic mode.

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

If you weeks ago they received the SYEF error code.
I changed the fan and it was working fine.
Now the temperature rises in the freezer 221 degrees or 18 the stuff are cold the freezer is not full but the temperature keeps on adjusting.
Please advise

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

WE HAVE A STACK UNIT WHERE THE WASHER WILL NOT START, NO TECH SHEET

  • Guest asked 6 years ago
  • last active 6 years ago
0 votes
2k views

Hi,
The microwave blowing fuse, I was testing the switches I found the normally closed one is no good, I changed the switch.
The microwave worked perfectly at that time, now when opened the door again, the fuse blowed up again. Now I need help on what I should do and what is the problem.
Thank you.

  • Guest asked 5 years ago
  • last active 5 years ago
0 votes
998 views

This is is a Frigidaire oven this the door lock error? Which board controls it if it is,? How can I check this issue?
I need a service manual and tech sheet and your expert advice.

  • Guest asked 3 years ago
  • last active 3 years ago
0 votes
3k views

My dispenser does not dispense any water or Ice. Although if I initiate the dispenser at the same time pull down with my index finger to initiate the movement , It does work. The other part is, If I loosen the screws holding the assembly in place and Pull it toward me just a little it also works. Very strange. I’m missing something, Just don’t know what it is…Can you help

  • Bob Henderson asked 10 years ago
  • last active 10 years ago
0 votes
2k views
  • nick asked 10 years ago
  • last active 10 years ago
0 votes
2k views

I apparently have the same problem as shown in your video. What is the part number for that part? If it’s not available, what would be the part that would work?

  • Matt Ferguson asked 9 years ago
  • last active 9 years ago
0 votes
3k views

I haven’t had a chance to physically diagnose this but want to take something with me since the customers requested the work be done asap for the holiday. I think it’s the console assembly but wanted to verify with you guys.

0 votes
2k views

my Frigidaire stove is displaying an F1 error code, keeps beeping and will not shut off.

0 votes
2k views

My Frigidaire washer keeps pausing mid cycle

0 votes
2k views

My Frigidaire stove is not heating.

0 votes
2k views

My Frigidaire refrigerator is not dispensing ice.

0 votes
2k views

We have a SXS refrigerator, customer complaint it’s frosting around inner door frame.
This customer has had 2 other companies out also. First company out, leveled unit ad adjusted doors.
2nd company out found no problem at all.
We were dispatched the call by Frigidaire. We went out the customer had cleaned everything up, so no evidence of a problem. We checked everything that could cause problem, nothing apparent. we advised the customer if it happens again. Leave it, don’t clean it so we can see it etc.
She called us out again in about 2 weeks (you have to love warranties like this) she had small frozen water spots on the lower freezer door shelves about the size of a half dollar. Similar to if the ice bucket was dripping although their is no evidence that it is.
1) ice door not leaking air and is closing in under 8 seconds.
2) no air leaks around gasket at all. Passes dollar bill test.
3) no air leaks around fill spout at icemaker
This one is a real head scratcher as it’s an absentee owner and anyone that is there is 0 help.
Tech line is NO help at all.
Has anyone else run into anything similar issue ?
Thanks in advance.

0 votes
2k views

I was getting an error message sy… and I was told to change the switch board under the front of the unit.
I changed it once it didn’t power up so I thought it was faulty.
so I changed it out for a new one.. I hot the new one and I have the same issue. it just will not power up

  • Guest asked 8 years ago
  • last active 8 years ago
Showing 61 - 90 of 395 results