The turntable inside the microwave oven continues to turn. won’t stop.
- Don Kopecky asked 6 years ago
- last active 6 years ago
One of the shelf supports on my Amanda microwave partially melted. I found and purchased a replacement. How do I remove the old support. Can I pry it off with a screw driver? Will this damage the interior. The shelf support part number is 2080030.
- Guest asked 5 years ago
- last active 5 years ago
My vent microwave exhaust fan does not work on the low speed but works fine on the high speed.
I have tried unplugging, waiting and plugging back in with no effect.
All other buttons on the touch pad seem to work just fine.
Any diagnosis tips or is there an obvious solution?
- scott asked 10 years ago
- last active 10 years ago
We have a Jenn-air oven/mw combo. Microwave starts counting down and then stops running and heating after 5 seconds. It starts counting for example 60-59-58-57-56-55-55-55-55-55-55-55-55. Never come across this before but assume it could be sensing an overheat and shutting off?
- Harley Clark asked 9 years ago
- last active 9 years ago
My Kitchen Aid wall oven microwave combo, that the halogen bulb in the microwave keeps failing every six months. Has anyone seen this situation before?
- Fred Abernethy asked 9 years ago
- last active 9 years ago
Getting error code f8e5 exhaust air temp sensor can’t seem to find a part number for that
- Guest asked 8 years ago
- last active 8 years ago
My microwave stops running after about 10 minutes of use.
- Patrick's Appliance Service asked 7 years ago
- last active 7 years ago
I found the primary interlock switch faulty on arrival, replaced and still had the same issue. The fan that comes on when the magnetron is active is only turning on when you open the door. I confirmed all the micro switches were functional at this point. My experience in the past is that one of the switches would cause this. I am suspectin that I am missing something here.
- Guest asked 7 years ago
- last active 7 years ago
Will not start up or respond to any touch. Completely unresponsive.
- Fred Abernethy asked 7 years ago
- last active 7 years ago
My GE microwave will not start or do anything.
- Gary Williams asked 6 years ago
- last active 6 years ago
I cannot get my GE microwave level.
- Curtis Appliance Repair asked 6 years ago
- last active 6 years ago
GE microwave oven is malfunctioning. With door closed and nothing set, it hums and the magnetron is definitely putting out. Turntable doesn’t turn and interior light doesn’t come on unless I set the timer, in which case the light comes on and the turntable turns. But, when time to stop, it beeps as normal at the end of the cycle and the turntable stops and the interior light goes out but the magnetron is still on and it is still humming.
Nothing will stop it except leaving the door ajar (and the light come on with the door open) or unplugging the unit. The clock works and I can (supposedly) set the power level and the timer for timed cooking, but as I said, when time to stop, the magnetron keeps running. I tried leaving it unplugged for a half hour hoping that would reset it, but it did not.
Edited to add: Everything on the touchpad seems to work correctly, but the magnetron will not turn off unless we leave the door open or unplug the unit.
GE Over the Range Microwave oven, model DVM1850DMBB
- Hall Refrigeration asked 6 years ago
- last active 6 years ago
I inadvertently put the microwave on for an hour thinking it was on the timer. It is dead now. Any ideas?
- Harley Clark asked 5 years ago
- last active 5 years ago
When opening the door on the microwave when it is still running it flips the breaker. A friend told us last night that should not be happening. Solutions?
- Hall Refrigeration asked 5 years ago
- last active 5 years ago
- Andrea Hurd asked 10 years ago
- last active 10 years ago
Microwave turns on for 2 seconds and then turns off. History: I changed out a blown fuse about six months ago but did not know at the time I should have changed the monitor switch. Last time it was dead and now it just turns on for 2 seconds. Any ideas what I should be looking for? Model #HMB5050/01 FD 9007100017 FCC ID ACLAP7A01
- Curtis Appliance Repair asked 9 years ago
- last active 9 years ago
Has SE error code any suggestions ?
- Patrick's Appliance Service asked 8 years ago
- last active 8 years ago
The microwave won’t start, what could be the problem?
- Guest asked 8 years ago
- last active 8 years ago
My microwave will not stop. it just constantly runs when you try to use it.
- Don Kopecky asked 7 years ago
- last active 7 years ago