Installed Thirmister s , temp sensor ,computer board , damper frost builds up on coil . Need to no how to do a force defrost on this model
- joejacinto123@gmail.com asked 3 years ago
- last active 3 years ago
I am looking for the service manual for my refrigerator.
- Curtis Appliance Repair asked 3 years ago
- last active 3 years ago
Water and ice dispenser control not working. Light flashing on dispenser control board. It’s the cold light that’s flashing. I replaced the dispenser control board and the light is still flashing. The dispenser control board is not responding to any buttons pushed.
- Georgia Steeler asked 3 years ago
- last active 3 years ago
need service manual for my samsung refrigerator
- Patrick's Appliance Service asked 3 years ago
- last active 3 years ago
I have watched your video on how to replace the ice maker for my refrigerator. I have removed ice tray and the side piece protector for the power cord and have the cord unplugged. Now I have the unit halfway out and cannot get it any further. I have pulled and pulled, is there a secret?
In the video he makes it look so simple.
I don’t know what else to try.
I’m afraid if I strong arm it too much I may do damage to something.
- Guest asked 3 years ago
- last active 3 years ago
Clicking noise issue
Fridge is 1 year old
Do you have an option where I might be able to speak to a Technician over the phone?
- Guest asked 3 years ago
- last active 3 years ago
Hello,
The samsung fridge is not cooling or freezing. I found codes 83 and 84 related to the compressor and went ahead and replaced the inverter board. The board light stays on steday and the fan runs on the compressor. I think this indicates normal operation. However its still not cooling or freezing. I don’t know if there are steps to take to reset the fridge. i have left it unplugged for an hour with the hope that it would reset and start to cool. I have also looked again at the error log and nothing new is reported. I ran the self diagnostic 2 fridge sensor error and received a “C” in the response thinking that a temperature sensor might be the problem. These are the parts I considering to replace but want to know if I’m in the right
Temperature sensor (DA32-00029Q)
Thermal fuse assembly (DA47-00301B)
- Guest asked 3 years ago
- last active 3 years ago
On my refrigerator the freezer is cold but the refrigerator is not cooling. Started about a week ago when the freezer was freezing over And the refrigerator and we heard a loud noise like. We were told we needed to unplug the fridge for a few days because the fan was hitting blocks of ice. So we did and now the noise is going but the fridge section will not cool down the freezer section is very cold. Do you have any idea what this could be?
- Guest asked 3 years ago
- last active 3 years ago
- Samsung Refrigerator mode # RF28R7351SR/AA
ICE shute opens and closes on its own. The display works fine and you can change between water, crush or cubes. The shute opens and closes repeatedly non stop. Dont know where to begin troubleshooting.
Thank you
- Guest asked 3 years ago
- last active 3 years ago
I have a Family Hub Refrigerator with 4 doors. The freezer section (bottom left) no longer freezes. The flex zone (bottom right) now seems to not be cooling as well as it use to (used as a fridge). Fault history shows error 83: Compressor Current & 84: Compressor Motor from about 6 weeks ago. However, those faults do not show anymore when running a self-diagnosis. I receive no errors during a self-diagnosis. I’m. trying to figure out if I should try replacing the PCB inverter board, or if it’s a more serious issue.
- Guest asked 3 years ago
- last active 3 years ago
I did replace the compressor and evaporator and heat exchanger on the sub zero model 680/s
Everything is running but not compressor,
Please I need advice and seal system service manual .
- Guest asked 3 years ago
- last active 3 years ago