The fan in my cooktop is making too much noise.
- James Buchanan asked 8 years ago
- last active 8 years ago
The back left burner is out on my GE cooktop.
- James Buchanan asked 8 years ago
- last active 8 years ago
The back left burner is not working on my cooktop
- Gary Williams asked 8 years ago
- last active 8 years ago
The controls on my Cooktop are not working properly.
- Don Kopecky asked 8 years ago
- last active 8 years ago
My cooktop keeps beeping and i cant get it to stop.
- Hall Refrigeration asked 8 years ago
- last active 8 years ago
The control panel is not working on my GE cooktop.
- Don Kopecky asked 8 years ago
- last active 8 years ago
The glass is cracked on my cooktop. how do i go about replacing this?
- Curtis Appliance Repair asked 8 years ago
- last active 8 years ago
Water keeps splashing onto the lock assy and shorting it out. Is there a solution to prevent that
- Guest asked 8 years ago
- last active 8 years ago
The front right burner is out on my GE cooktop.
- T&G Appliance Repair asked 8 years ago
- last active 8 years ago
The controls on my cooktop are not working.
- Patrick's Appliance Service asked 8 years ago
- last active 8 years ago
this unit was getting cool and cut off I change the temp sensor know the interface is flashing 0 0 can this be reset
- Guest asked 8 years ago
- last active 8 years ago
I cannot figure out how to adjust the leveling legs on my range.
- Harley Clark asked 8 years ago
- last active 8 years ago
The door on my GE oven will not close properly.
- Gary Williams asked 8 years ago
- last active 8 years ago
The fan in my oven sounds like its rubbing up against something.
- Curtis Appliance Repair asked 8 years ago
- last active 8 years ago
The controls on my GE oven are not working properly.
- T&G Appliance Repair asked 8 years ago
- last active 8 years ago
My oven is not keeping the proper temperature.
- Harley Clark asked 8 years ago
- last active 8 years ago
We’ve been out 3x now and customer is beyond frustrated. We have changed the heating element and the thermostat separate calls. Both times machine tested and cleared as working but when the customer put it in use, no heat.
- MRAFRED asked 8 years ago
- last active 8 years ago
Timer set at normal for 44 minutes dryer run for 5 minus and jump to 1 minutes and dry time come to an end. same thing when set to heavy duty for 1 hour, dryer run for 5 minute and jump to 1 minute and dry time come to an end.
open up the dryer and run test on normal dry time and heavy duty dry time same thing happened. Burner igniter glow Jerry red and turn off gas valve open and flame come on for about 20 second and turn off one minute burner igniter glow again, gas valve open and flame come on for 10 seconds and shut off. 2 minutes later dryer sound the tone dry time is end. exactly same thing happened when i use heavy duty and any other dry option please help diagnose step by step to pin point the main issue.
- Guest asked 8 years ago
- last active 8 years ago
Hello, I have a bosch dryer that shuts off after 3 mins of run time heat is good timed dry cycle ok only on any auto dry cycle changed thermistor cleared condensate and lint trap still same problem any help. Thanks
- Harley Clark asked 8 years ago
- last active 8 years ago
we need to disassemble the dryer. it is noisy. do you have a video?
- Guest asked 8 years ago
- last active 8 years ago
tried new pump with old board and old board with new pump and new pump with new board same issues
- Guest asked 8 years ago
- last active 8 years ago
Customer called and complained about dishes not being clean on bottom rack.
- Guest asked 8 years ago
- last active 8 years ago
food side not cold, the evaporator coil is completely frost and ice, vent is not block. evaporator fan blowing, temperature sensor, heating element and by metal thermostat all have continuity. what are the step by step on how to diagnose to pin point the correct faulty part. please help
- Guest asked 8 years ago
- last active 8 years ago
