Appliance Type: Dishwasher

I am going to ask this question again – I think that maybe I am not sure how to use the site – because I am not sure how to respond to the answer that Matt provided to me. The answer was not helpful because as I indicated I had already turned the power off to the dishwasher and that did not work.
Hi Mat The clean light flashes 4 times, stops for a bit and then flashes 4 times again continuously (the manual identifies this as an error code. I did unplug (power off) the unit and the problem was not corrected. I also sequenced through pushing the High Temp. Scrub and Heated Dry buttons several times as was identified online as a reset, but this did not work either. Is there another way to reset this model?

Complaint: Unit taking very long time to complete cycle and or pauses with water,
but will complete cycle. This unit is located in a Seminary with multiple users so can’t get proper feedback. Any help appreciated.

I am working on a GE dishwasher model# GLD4456R00CS and the unit had gotten hit by a power surge and burnt out control board. I replaced control board kit ( cam with both control board and touch control board w/ connector harness). Now the clean light keeps blinking steady no pauses, and the touch pads do not work. I checked connections but all good. A bad new touch control or something else? No service tech sheet in unit.
Any help greatly appreciated thanks.

I HAVE A CUSTOMER WITH THIS KITCHENAID DISHWASHER WHERE THERE ARE THREE LIGHTS LIT UP ON THE PANEL WHEN POWER IS SUPPLIED WITH NO RESPONSE TO OPERATOR INPUT OTHER THAN THE OPTIONS BUTTONS. REPLACING THE TOUCH MEMBRANE- PART # W10077793 RESULTED IN THE SAME THREE LIGHTS BEING LIT WITH ONE ADDITIONAL-HEAVY WASH, AND NO RESPONSE TO OPERATOR INPUT. WAS WONDERING IF THE CONTROL BOARD, RIBBON OR INTERCONNECT COULD BE AT FAULT. HAVE NEVER SEEN A CONTROL BOARD AT FAULT FOR THIS PROBLEM BEFORE. HAVE ALWAYS SOLVED THIS PROBLEM AT LEAST TWENTY TIMES BEFORE BY REPLACING THE TOUCH PANEL. THE RIBBON AND INTERCONNECT LOOK LIKE STRAIGHT DATA TRANSFER TO ME.

Hi, my dishwasher randomly came on with a blinking clean light. I watched your informative video on how to reset the codes on other whirlpool dishwashers, mine however doest have the same button setup, and am curious if you know the button combination to reset mine. Ive inspected to element and put a multimeter on it to read the ohms, this checks out as fine. any help would be much obliged.

-bill

Start button does not work.

My dishwasher doesn’t want to drain completely. Initially I thought it was something stuck and cleaned out as far as possible down into the impeller or chopper area like a video I saw on here. Ran another cycle and same thing happened. Could it be something stuck further in the drain or pump area?

hello

I have a kitchenaid dishwasher that starts to fill and stops before it reaches the float. the float moves freely and the float switch itself is good and electically works

any idea where to go next

thanks
james

Hi, I have a Fisher & Paykel DD605. The Control Module cover has 2 IR lenses on the right hand side. One of the lenses has a strange build up in the lense causing the IR to not pass through. Basically I’m looking for a Control Module cover plate only. Any help would be greatly appreciated.

Thanks,
Ed
732-259-6204

I just watched the video on how to repair my top rack which came loose on my dishwasher. Thank you so much. I was able to fix it.

Marjorie

drawer lid works intermittantly. had the lower replaced 6 months ago for same issue

I have a E01 error code on a Ascenta Dishwasher? any suggestions