Appliance Type: Washer

My washer wont spin out

My Whirlpool washer is making an odd grinding noise.

When you try to run a wash cycle and push start you can hear relays clicking but nothing happens. We have the tech sheet but when you try to run the quick diagnostic test it will not advance past c00.

My washer is hard to start. I put it in diagnostic mode and get codes F0 E3

This unit has a door that’s not closing properly, and possibly a control issue. I explained to the customer that it could be either, but would a new door hinge really be the first route to go, or should I also order the control just in case? The door latches and isn’t leaking, but it doesn’t sit correctly.

Customer complaint is that it’s been throwing unbalanced errors. They will go on to readjust load but that does not help. All they can do at the point is drain the water.

Looking for any suggestions

Electrolux. No matter what setting it’s set to the washer always uses scorching hot water. Coworker replaced valves and main board still only using hot water though. I have a kenmore today with the same issue and just wanted to know what it could be causing it? Hoses installed correctly, settings are properly set..

There is power to the washer and the led on the main board is illuminated. But if I push the power button it usually doesn’t come on. If it is unplugged for half a day it may work half a cycle and the same thing happens. The power button on the circuit panel is ok. What is the issue? Have you seen this before? What tests can I do? Where do I start?
How do I do the diagnostics on this washer? It only has a USB port. Is the smartphone any good and will it work if it doesn’t power up? Will it detect this problem?

whasher works fine on first load, goes through all the cycles and clothes come out as it should, it fails on second load to spin on high speed, it rinses fine, but it wont go through final spin (high spped), so clothes are too wet, no error codes, diagnostic shows no problems, it keeps trying to balance I guess but it wont go through with it and it times out after too many attempts, I`ve replaced the pump, think it has a faulty pump, shocks looks good as well, need help with this customer machine problem, cant keep replacing parts, any idea?

I recieving an error code F dy and cannot find what it means or is referring to

Machine does not complete cycle – no spin

My Whirlpool washer is leaking.

Washer isn’t going into spin cycle?

Need help diagnosing unit. Also is there a video on how to take off the top panel off to see the inside. Please help

This washer comes up with an “INT” code and will not complete cycle. “INT” has something to do with interupting but it wont go away and you cannot change any cycle. Looking for any service updates for that model.

I have a top load washer with a mechanical timer that is stuck in a spin cycle. No matter what setting the timer is on it just goes into a spin.

Code11 shows up, which is the MCU. How can I check to make sure that is what is wrong. Kenmoe Elite HE4T

There is a grinding noise during agitation. I have cycled through the service mode and in agitation cycle there is grinding noise.

What part or parts do I need to order to fix this before it becomes a bigger problem.

Thanks

I washer a large load today and now my washer will not spin. I seems to drain and fill ok and I can hear the motor when I put it on drain only setting. Can you please tell me ways to diagnos and fix the potential issues.

Thanks

do you have a tech sheet for this front load washer.

Customer brought washer said was not draining properly. When we tried washer made humming sound lid lock kicks in and out then no water comes in and nothing happens. lid switch light stays flickering