0 votes
2k views

The washer is spinning, but the clothes are still wet. About 6 months ago changed out pump because it was not draining. Is there an actuator or a motor sensor?

0 votes
3k views

My GE dryer will not spin.

0 votes
4k views

My GE dryer is making a loud noise while running.

0 votes
2k views

My GE dryer is not drying properly.

0 votes
2k views

The door on my dryer will not stay shut.

0 votes
3k views

Dryer will not heat up

0 votes
2k views

My GE dryer is not heating.

0 votes
2k views

No power.

0 votes
4k views

Dryer will not run, Display is blank

0 votes
2k views

error codes.

0 votes
2k views

error codes.

0 votes
4k views

Dishwasher rack is uneven, Rack falls out

0 votes
3k views

The rack in my dishwasher keeps coming off track.

0 votes
5k views

My dishwater is leaking water from somewhere.

0 votes
4k views

My dishwasher is not draining properly.

0 votes
3k views

Door just falls open.

0 votes
2k views

My KitchenAid dishwasher will not fill with water.

0 votes
3k views

Keeps shutting off.

0 votes
2k views

Lights on console display error code

0 votes
3k views

Rack will not roll out, Rack will not slide out.

0 votes
3k views

Lid is difficult to open

0 votes
3k views

The lid on my washer will not close.

0 votes
2k views

Puddle of detergent on the floor

0 votes
4k views

Error codes.Will not spin.

0 votes
3k views

My washer will not spin out.

0 votes
3k views

Hello Technicians, this is a follow up question, from my last question on this Thermador dishwasher.
I have checked all that was suggested from my last question on this product. Drain is clear and unobstructed. Wash arm spray nozzles are clear, detergent dispenser is working properly. Two things I have found ,when upper rack only is used and then you return to both racks the plunger that diverts water to the top rack sticks in the closed position and bottom spray arm does not work , I can take the spray arm off and take my finger and press the plunger down and the spray arm functions properly. I have also noticed the water in the tub is only 110 degrees. The flow through heaters do not come on and heat the water until about 30 minuets into the cycle, according to the service manual the dishwasher will pull 11 amps when The heaters are activated, the dishwasher pulls 1.5 amps for the first 25 to 30 minuets of both normal and heavy wash cycles. Can you advise me on how long into the cycle is normal for the heaters to begin operation and also the best way to stop the plunger from sticking. Any advise is appreciated.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

do you have any repair videos on this washer?

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
11k views

I have a GE dishwasher and the Vent Cover keeps “Popping Off” and the is Vent Leaking . Is there a fix for this issue ?

0 votes
3k views

My GE washer will not drain all the water out of it.

0 votes
3k views

no water.

Showing 3211 - 3240 of 9k results