Repair Help

No display, No bake, No broil, Cooktop wont function.

Will not lock for self clean cycle.

No bake or broil.

No power, No bake no broil, Surface element doesn’t operate.

No display, No bake, No broil.

Will not run.

Surface element not working.

Surface element not working.

Fan will not run, No power, Lights will not come on, Compressor will not start.

Fan will not run.

Water in freezer, Will not make cubes.

Refrigerator not cooling, No power to the defrost heater, Intermittent cooling.

If you weeks ago they received the SYEF error code.
I changed the fan and it was working fine.
Now the temperature rises in the freezer 221 degrees or 18 the stuff are cold the freezer is not full but the temperature keeps on adjusting.
Please advise

Hello
We have A Sub-Zero refrigerator that the (Vacuum condenser) light will come on within 24 hours after resetting. This is A dual compressor system and the unit is running prefect temperatures in the Freezer and refrigerator section. The freezer is at -1 degrees and the refrigerator is +38 degrees consistently. The condenser and condenser fan motor are clean. We even removed the condenser motor and cleaned the condenser with Co2. This condenser is spotless, you can shine A flashlight through it. I know the vacuum condenser light is an inefficient unit operation error. We pulled both evaporator covers in the fresh food and freezer section to verify they both have an even frost patter, we wanted to make sure there was not A starved evaporator before tapping the sealed system. We called the technician line at Sub-zero, they told us to tap the freezer and refrigerator section to check the pressures. We are not going to do that with perfect operating temperatures and even frost patterns on both evaporators. With perfect cooling temperatures in both sections is there any other suggestions before moving to the display board? Thanks in advance

This is a Hobart commercial dishwasher. The cycle runs fine it washes, it drains, rinses and drains. The next morning there will be standing water in the bottom. A slow trickle can be seen coming from the inlet tube. Is there anything except a leaking inlet valve that could be causing this problem?
Andy

Never had to replace one of these motors just need a video so I have some idea where to start. Thank you for your help.

No air flow, Ice build up, Ticking sound from inside refrigerator.

Fan will not run.

Cool air escapes refrigerator section, Frost build up.

Handle is scratched.

There was a field change on the freezer section ice maker to keep the water chute from icing up. It was some kind of insulator I assume, but it shriveled up to uselessness and needs replaced. I cannot find the part from the diagram. Ice builds up and causes the water to be partially diverted. Where can I find these and how do I get modifications on various appliances.

Need to replace evaporator in fresh food section. WR85X10065 part comes as whole assembly including evaporator, fan motor and drain heater. Does anybody have any videos/directions/instructions?

Water will not shut off, Dispenser door will not close.

No ice or water at dispenser, Will not produce ice, Water drips from dispenser.

Will not produce ice, Leaking water, Buzzing from the back of the refrigerator.

Burning smell, Compressor starts then shuts off, Refrigerator is hot to the touch.

Burning smell, Freezer will not get cold, Refrigerator will not get cold, Fans will not stop running.

Motor will not run, lights come on but will not start, electrical burning smell.

Fault code is displayed, will not run, will not heat, display will not light up.

Drum bounces around, grinding sounds while running.