Repair Help

Garments are still wet at end of cycle, cycle will not end, burning smell.

Motor will not run, lights come on but will not start.

Steam cycle will not work, garments are not refreshed.

Steam cycle will not work, garments are not refreshed.

Clothes come out wet, light comes on but will not run.

unit will not stop running, dryer shuts off too soon, front panel is hot to the touch.

Unit will not run, will not start.

Clothes are getting torn, laundry ends up in a balled up or knotted the end of cycle.

sticker is pealing off, settings are unreadable, console is loose.

Display is blank, no voltage to the motor, error codes are displayed, Fault code 151.

Unit beeps then Error codes are displayed, display is blank, powers up but will not run, Fault code 151.

Leaks water, humming sound, dishes are not getting clean.

Leaks water, dishes are not getting clean, soap does not disolve.

Standing water, leaking water, bad smell.

My dishwasher will not shut off.

Buttons will not respond, start then shuts off, will not fill.

10yr old $10,000 viking that will not dispense water and slow ice production. water line inside of freezer door is frozen. freezer temp is normal,should I just replace ice maker? can the freezer door insulation become compromised? is there a water line heater in the door?

I can unplug the unit for 24-48hrs and the water will work for a couple of days then it stops. I have water flow from line just before it enters freezer door. so i know its freezing inside of freezer door.

Hello,
First of all thank you for producing the great instructional videos that you do. They really are a god send for amateur DIY folks like myself who have some mechanical skills but are approaching a new problem they are unfamiliar with – in my case a warm refrigerator.

I have a Sub-Zero refrigerator (model # 650/S) that won’t cool below approx. 50 degrees in the main refrigerator section, (the freezer section works fine). I’ve cleaned the condenser coils and cleaned the door seal, but the problem remains. I checked the condenser fan and it is running OK. I checked the compressors and both are warm and have a slight vibration, indicating (to me at least) that they are working. The evaporator fan in the man section of the refrigerator works OK as I see it spinning when I open the door. I removed the back panel of refrigerator to expose the evaporator coils and observed frosting only on the top left section where the tubes go into the evaporator. Everywhere else on the evaporator is free of frost and warm to the touch. Does this indicate a refrigerant leak at the join and necessitate replacement of the evaporator and unit recharge? Are there any other possible causes that I should check out before purchasing a new evaporator?

Thanks,
Eoin.

My fridge is working fine and making ice ok.

Won’t dispense ice or water. I have pulled front cover off, both switches are in place and freezer door switch is ok.
What could be wrong?

Thermador

Ran through diagnostic mode all major components seem to check out and service manual with that unit does not have a F 36 code. The unit seems to come on normally but as soon as you hit a function it flashes the Error and shuts off. Can you guys give me an input not just the manual it doesn’t seem to have an answere.

will not fill, bas smell, slow fill.

Door stays open

Door is heavy, door will not close, leaks water.

disher are not getting clean, soap at bottom of tub.

door will not stay closed, control will not respond.

Plastic is worn out.

No lights, will not run, cycle shuts off, will not fill, will not heat.