Appliance Type: Dishwasher

My GE dishwasher is leaking water from somewhere.

The washer does fine till near the end of the spin cycle at around 5 minutes then he jumps back up to 9 minutes and repeats this cycle over and over. I have confirmed that the washer is level, completed recalibration and have ensured proper drain hose installation as well as clean the pump trap.

I am thinking the water level pressure switch must be the issue making the control board think that the washer isn’t pumping out completely.

does that seem like a good call to make? I took it all apart and didn’t find anything that is rattling. the motor is not touching the floor, it is leveled and its extremely nosey.

maytag

Looking for Service manual model QDT125SSK

fast wash which is a 30 minute cycle goes down to zero and then it turns back on again and went to 15 mins cycle…. for the 15 mins cycle then goes through another wash cycle….so the 15 mins wash it went down to zero and everything drained and there is no water in it now so it works on the 15 min cycle and not the 30 mins cycle (wont turn off on 30 mins but shuts off on the 15 min cycle)….for the 30 mins has to shut off manually which then leaves water in the dishwasher

No lights, will not run, cycle shuts off, will not fill, will not heat.

Metal sound when opening and closing the door.

Leaking water.

On my Maytag dishwasher (mdb7749sab0) the lights don’t come on when I press Start. It won’t start. Happened yesterday and then it worked. Also, it worked again today, but tonight, the problem is back. Press Start and nothing.

I have a Whirlpool Gold Quiet Partner III and the Control Lock (press & hold) light is on and it will not let me run a cycle. How do I turn this off and use my dishwasher again?

Dishwasher 2950 the panel goes black. turned off breaker and turned on. panel lit up, but sounds like its running for a few minutes then stops.

DISHWASHER WILL NOT DRY DISHES WELL, HEATER HAS BEEN REPLACED AND DOES HEAT BUT CUSTOMER STILL COMPLAINS THAT DISHES ARE NOT DRY ENOUGH, WATER DOES NOT GET HOT ENOUGH.

LOOKING TO SEE IF THERE IS SOME SORT OF A SERVICE UPDATE FOR THESE NEWER STYLE WHIRLPOOL DISHWASHERS, WE SEEM TO RECEIVE MANY COMPLAINTS LIKE THIS.

THANKS

It will start and run for awhile and cut off.Then when you restart it, it runs for 10/20 seconds and cuts off, restart and runs for 10/20 seconds. You get the idea. Please I’m old school, need help telling me what to check and how. Don’t like to have to ask, but i’m new to all is electronics stuff. Thanks Chip

My dishwasher is reading a CE error code.

My KitchenAid will not start or do anything at all.

After beginning a cycle, the initial fill seems to take longer than normal. After a few moments, the unit begins to drain (without beginning to wash) and the “Smart Auto” light blinks.
I have cycled power to reset.
I have also already replaced the thermistor.
There is no water in the drip tray beneath the unit.

I HAVE AN ASKO DW D3232XLFI SERIAL IS 065101457188 DOSE ANY ONE HAVE A TECH SHEET ON ERROR CODES AND REPAIR ON THIS MODEL THE UNIT WILL START OUT OK THEN RUN ABOUT 13 TO 15 MIN DRAIN OUT ALL THE WAY. THEN GIVE AN ERROR OF LIGHT BLINKING ABOVE HEAVY WASH AND IT SHUTS DOWN AND WILL NOT GO INTO A FILL. WE REPLACED NEW WATER VALVE TWICE AND A PRESSURE SWITCH ALSO AND CONTROL BOARD PER TECH LINE STILL DOING THE SAME THING I AM GOING OUT MYSELF TO TRY TO GET TO BOTTOM OF THIS HOPE SOMEONE CAN HELP THANKS

I would like your recommendations for appliances that will last longer than 6 years like most of the brands that are produced today. My customers ask me this question daily. I suggest Speed Queen washers and dryers for laundry products but I’m not sure about the other types of appliances. I’m currently researching Bosch dishwashers. Thank you for any assistance.

KUDS30IXBL8 – Black
KUDS30IXWH8 – White
KUDS30IXBT8 – Biscuit
KUDS30IXSS8 – Stainless Steel

How many times do you have to push the buttons in the right time