Appliance Type: Stove / Oven / Cooktop

The customer States that after a self clean on the oven the thermostat light indicating what selection is chosen does not work I have tried to put it on bake or broil even self clean and nothing happens there is a light in the oven itself that does work and the top burners are working as well

hi so we have 2 issues with the stove top.
1. the two middle burners will not light by itself i hear the clicking but it sparks at the rear right not the middle where i want to light it.
2. the left and right front burners have a real small flame.. there is very very little gas flowing to the burner hence the small flame

I need any advice and Tech sheet

Do you have a video on how you replace the bake element on this double oven. I also like to know if you have a diagnosis sheet or cheat sheet that I can put the unit into diagnostic mode? I don’t have anything on this oven except a schematic. Takes a long time to get to preset temperature 30 min.

I have changed the eoc and still get f30 the wires from the sensor all check good. The resettable thermal fuse was not tripped. The sensor is good ohms out the same as a new one. The last thing is the user interface . Is it a thing with this style of oven for both to go bad.

The door is not locked however I’m still getting this message.
It happened once before we unplugged it and it worked fine now however we unplug it we get the power failure message and then F5 E7

This unit has a hidden bake element. I’m wondering how to remove it. It doesn’t have any screws on the inside to remove the bottom panel to get to it.

the touch pad display went blank on our 10 year old oven during the night. Time does not show. No touchpad selections work except to turn on the oven light. Every few hours the oven will beep several times on it’s own. Only once however, did the error codes appear. When we try to use the various touchpad features, we get either one or several beeps, but nothing shows on the touchpad screen. I turned off the circuit breaker for 10 minutes and then turned it back on; no change. What do the error codes mean, and how can this matter be fixed?

Eastoriver

I did not hear any clicking from the igniter I suspect that may be electronic spark module however the bake igniter works perfectly

Are you able to get me the part number to the entire cartridge, including burners and all, where all I have to do is swap them out and not rebuild the entire thing?

We have this cooktop and it is giving a f122.Anyone know what this could be?

the oven will not work .
the screen is blank
the burners do not light with the electric
only by match

The knob on my oven is broken off.

Customer says that they can only turn on one out of four burners. one comes on and when they attempt to activate other burners, they get intermitent flashing LED lights on readout. There are two LED readouts. one on left and one on right. after they activate the one burner and start to activate the others, the error code appears. left LED displays
” E ” and right LED displays ” 32 “. Sounds like control board but not sure.

My Samsung range is displaying an SE code. Have you seen anything like this before?

My GE stove is tripping the breaker when it powers on.

My Whirlpool stove is not reaching the proper temperature.