0 votes
2k views

3 in 1 hard start. I’d like to start using these when fridge relays go bad, but how do I know which one to choose? In this case, it is for gsh25sgrbss.
Tom

0 votes
2k views

Hi! The freezer on my 2 year old GE fridge/bottom freezer seems to have gone into overdrive after a recent power outage. The water line to the water in the fridge door is frozen and the cheese in bottom crisper drawer in the fridge above the freezer are blocks of ice cheese. Any tips?

0 votes
2k views

Samsung RF260DEAEBC French door with out Ice maker in door. Ice maker is located in the freezer. How do I adjust the cube size?

0 votes
3k views

Our Whirlpool refridgerator GI5FSAXVY02 control panel is completely black. It beeps if you try to get water, but nothing else. My quesstion is, I don’t think the compressor is running, I think the panel must control that. the lights in the refridgerator are on though. will replacing the panel fix the problem?

0 votes
4k views

The 5 refrigerator LEDs went dim then the freezer LEDs quit. The tech sheet doesn’t show the dc voltage test on the aurora board. I watched the premium video on this one but it didn’t show how to test this condition. I replaced the aurora board but it didn’t help.
Is there any way to test the LEDs?
Could it be a bad splice or connection?
Is there a voltage test I can perform at the aurora board?
Is there a service manual that might help?
Have you seen this condition?
If it is a wiring issue where are the splices and connectors at?

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
3k views

Kitchenaid Superba

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
3k views

I killed it while I was wiping down the doors and handles. Touched too many places in the control panel.

0 votes
2k views

My Samsung RF267AERS ice maker is not making ice. I’m not sure if I should replace the ice maker or the water value. I do receive water thru the dispenser on the door. Thanks

0 votes
3k views

Fresh food section / refrigerator Is not defrosting and restricting the airflow with the giant block of snow. Ran the system through self diagnostic mode nothing came up but when I ran the sensor diagnostic out of the ten sensors it tested, sensor #7 failed.
Now here’s the issue, the whole system is a cluster of bunch of plastic parts
IS THERE A MAP OF THE TEMPETURE SENSORS so I can find #7 instead of finding all 10 and having to test manually?

(In Samsung category because wouldn’t find GE brand and unit compressor was Samsung)

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
3k views

The compressor, inverter board and main control board was changed. Before the unit was not cooling (compressor issue) and there was a audile beeping noise also compressor would try to start. NOW after everything has been changed out. There is a clicking noise and the fans will stop momentary and come back on. Also when that happens the temperature display in the top inside of refrigerator will dim. Like I noted, fans will stop and come back on, but the compressor will stay running until set temperature is reached. Please in any way possible. Thanks Ricky

0 votes
2k views

Our ice maker in the bottom freezer does not work. We also hear a crackling/clicking sound. We vacuumed the bottom really well but still no luck.

0 votes
2k views

I have an Amana AFI2538AEB4 refridgerator. The control panel is not working. The power is good. The interior refridge light is on. If I press any button on the control panel every light and number lights up. So that means the control panel has power. Is there some type of reset?

0 votes
3k views

Maytag MF12568AES refrigerator control panel not working. Yesterday came home and lights on control panel were out and it was just buzzing. I believe the fridge is working. We have had issue for past year with switching from water and ice so we have just left it on water. Which should I replace – control panel on back, control panel on front, or display panel. How can test to figure out which is bad. I unplugged the connector with three wires attached to control panel on the front and it lights up as normal but no water and cannot use any of the buttons.

0 votes
2k views
  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

Refrigerator quit cooling ,lights on control panel are off , heard a clicking sound with the contol panel lights turning on and off previously to this. It is a Maytag model #MF12569VEA1 refrigerator/ freezer.

0 votes
3k views

The control panel on our refrigerator is not working. Push any button and the panel lights all come on and beeper sounds.

0 votes
13k views

How do you reset the control panel on a Maytag refrigerator, model #MFI2569YEM0 display board lights up when you touch any button beeps when you push water or ice button but no lights unless you push a button

0 votes
4k views

Refrigerator quit cooling ,lights on control panel are off , heard a clicking sound with the contol panel lights turning on and off previously to this. It is a Maytag model #MF12569VEA1 refrigerator/ freezer.

0 votes
2k views

We have a monogram refrigerator and the ice maker will not dispense whole cubes–it puts the ice through the grinder whether we use the control for the whole cubes or the grinding portion. Any simple fix or is it broken?

0 votes
3k views

Ge side by side fridge model GSC23LSRDSS. Fridge side is a little warm, about 45 degrees at cool setting 5. Cranked up to max cool (9) it barely gets to 40. Evap coils lightly frosted all over. I had found the evap fan was not moving. I replaced the fan and the circuit board. Still having problem with fridge not quite cold enough based on refrigerator thermometer. I removed the damper and it appeared to be wide open when completely removed and unplugged. It flopped about 1/4″ when shaken, and looked like it might be hitting the corner of the fan. That fan works, by the way. I was unable to get it in any position other than just about wide open by shaking it. It seems like it ought to be too cold, not too warm! I put it back together and I’m stumped. My customer already paid for a new evap fan and circuit board and I’m not confident that replacing the damper will help, even though it may be broken. What else might cause this?

Setting the fridge at cool level 5 brings it to about 44 degrees. At 7 it gets to about 42, and it barely gets to 40 when set all the way to 9 (max cool). The freezer will get down to -9 at max cool. No defrost issues that I can see. Nothing blocking the air flow into the fridge.

  • Guest asked 7 years ago
  • last active 7 years ago
1 vote
3k views

freezer not cold enough, refrigerator works fine

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
2k views

Unit was not making Ice. Ice maker was replaced with ice maker WPW10300024. Now making ice at the rate of 2 harvest in a 16 hour period(i had the customer count the cubes, 14 cubes in 16 hour period). They are also complaining that the cubes are small but i believe i can correct that with the adjustment screw on the ice maker. My question to you is: Is it making ice at the correct rate? Should it have harvested 3 times last night? Any service bulletins on slow ice production, if this rate could be considered slow? A tech sheet on the fridge and ice maker would be great also.

  • Guest asked 7 years ago
  • last active 7 years ago
0 votes
3k views

I purchased a Fisher & Paykel fridge some years ago and now the handle on the fridge has broken off. The top of the handle is a hook that goes into the door and the bottom looks like it had a lug into the door that has sheared.

0 votes
1k views

I have a Maytag side by side fridge with freezer drawer on bottom . its 3 years old. Yesterday it stopped working out of the blue. The lights work but it does not have a running sound and is no longer cold. when i unplug and plug back in there is a hum and load knock at the ice maker screen and then nothing. Im assuming the compressor failed . But after 3 years ??/

0 votes
3k views

We have a Samsung fridge displaying FF

0 votes
2k views

Pan under fridge is full of scummy water, should I clean it and add water and replace? its a Viking Professional 36″ refrigerator with freezer on the bottom.

0 votes
2k views

Whirlpool fridge beeping and clicking, not cold enough. Side by side model gc5shexns05.I hear a random relay clicks and the evap and condenser fans both shut off for a few seconds then come back on for 20 or 30 seconds on average, but it seems random. The relay that is clicking sounds like it’s in the plastic box to the left of the compressor when looking from the back. I unplugged it for a few minutes and it continues, but now there is also a double then single beep coming from what sounds like the same location. The fridge is warming up. The evap coils look a little icy and some frost on the back panel, but not a ton. I didn’t take the back of the freezer off, I was just looking through some slots and could see the bottom of the evap coils, so I don’t know how badly they are iced up, but they looked a little icy from what I could see.The compressor seemed to continue to run when the fans clicked off. What do you think is the problem?
Tom

0 votes
2k views

I have a Maytag side by side fridge with freezer drawer on bottom . its 3 years old. Yesterday it stopped working out of the blue. The lights work but it does not have a running sound and is no longer cold. when i unplug and plug back in there is a hum and load knock at the ice maker screen and then nothing. Im assuming the compressor failed . But after 3 years ??/

0 votes
3k views

What does it mean when the control panel display shows OF on freezer and refrigerator sides ?Samsung model # RS267TDRS.

0 votes
2k views

My kitchen aid bottom drawer ice maker stopped making ice.

Showing 631 - 660 of 3k results