Repair Help

What does this part do? Does it recycle the water. I would like to know. Will it stop the dishwasher from turning the motor on if it doesn’t work?

NO POWER TO COMPRESSOR.

PRIMARILY I NEED THE SCHEMATIC, BUT I’LL TAKE WHATEVER YOU HAVE.

TX

My question has nothing to do with the specific model number of above. A coworker and I changed out a bad compressor. It ran for 2 days, then stopped. We were discussing our problem with other techs. One of the other tech asked us how we filled the new compressor with freon. We told him that we filled it with liquid on the low side line like we always do.
He said that we improperly filled the compressor and thus, broke it. He told us that the only way to properly fill a compressor is liquid on the high side and vapor on the low side. Now, we have made over 25 compressor change outs, and never had a problem.

What is the “only” or is there an “only way to fill a compressor?

I replace the main control board, defrost thermostat, and defrost heater and still have the problem.

Are you able to provide the tech sheet for this model? Model# PFS22SISBSS There is not one with the machine. Thank you.

THE UNIT RAN OVERNIGHT AND IS COLD ON BOTH SIDES. I WENT THROUGH DIAGNOSTICS AND ALL THREE FANS CAME ON. THE TEMP SENSORS ALSO WERE WORKING CORRECTLY. THE FANS DON’T COME ON DURING NORMAL OPERATION. WHAT IS YOUR OPINION ON THIS ISSUE? THIS DOESN’T SEEM RIGHT TO ME. ANY THOUGHTS?

This is a General Refrigerator made by Samsung. It has the two boards on the left side on the back of the refrigerator. I believe this is a relay problem in one of the boards. How do I troubleshoot this unite?

Do you have a video on this model showing how to get to auger and icemaker?

I’m emailing you to see if I can get your help on a WRF989SDAH00, serial # K23703651. The refrigerator fans are all working good but the freezer is not cooling completely. If you can please help me out here id greatly appreciate it.
Thank you.

The refrigerator is not cooling at all but the fans are working could you help me out with this. Thank you

When the ice maker calls for water it comes out into the Icemaker and out the water dispenser on the floor. But when you push the water paddle you get nothing. I have never had a box act like this. Water valve ohms out o.k.

NEITHER EVAP FANS ARE COMING ON. I’D RATHER BE ABLE TO T/S IT FROM THE BOARDS BEFORE I HAVE TO DISASSEMBLE BOTH SIDES TO GET TO FANS. MY THINKING IS THERE IS AN ISSUE THERE AS IT SEEMS UNLIKELY BOTH FANS WOULD GO AT THE SAME TIME. ALSO THE UNIT DOESN’T HAVE A DATA PLATE AND I NEED TO FIND OUT THE PROPER CHARGE. SO ANY TECH SHEETS WOULD BE HELPFUL.

ALSO IF YOU CAN LOOK AT MY LAST INQUIRY, I ASKED A SECOND QUESTION AFTER THE INITIAL ANSWER. I STILL HAVEN’T RECEIVED AN ANSWER ON THAT IF COULD LOOK INTO THAT FOR ME ALSO. THANKS IN ADVANCE.
BILL

Need information on this dual fuel wolf stove. How to replace the thermistors in the oven? If you have a break down or know how to get into the oven and change the oven sensors?

Error code sheet for GE washer, Tells you what all the error code are according to the flashing lights of the led on the inverter board. Please send a Error Code sheet?

I’M THINKING THAT THE DIVERTER IS NOT WORKING PROPERLY. I NEED TO KNOW HOW TO PUT THE VALVE IN THE HOME POSITION. I ALSO NEED TECH SHEETS TO DETERMINE IF THIS IS A VALVE PROBLEM, BOARD PROBLEM OR A THERMISTAT PROBLEM.

Customer reports dishwasher leaking water ,technician diagnosed the dishwasher replaced the gasket beach ,the gasket tub plastic .now it won’t start we replaced the door switch it still won’t start all the lights are on and work we disconnected it to reset several times.can you help me ?

I have the paperwork but dont understand it, i am new and lack of experience
A video would be great help. Compressor does not turn on, everything else seems to, inverter board flashes 2 times

Where do you get another fuse? White with red stripe with electrical tape around it. Does GE sell the fuse for this unit. Can I pick up one at radio shack? Let me know?

the freezer is working fine the cold section is not blowing any air at all I also do not hear the fan

Dishwasher motor doen’t run, Drain works when you it cancel. Unit won’t go into diagnostics. Is there a video that shows you how. I tried any key 3 consecutive times within 1 sec. closed the door. won’t go into diagnostics. Does the tubulity sensor have anything to do with motor running? I’m sure if i’m doing it right to put to diagnostics. They say it has to be in stand by mode. Is stand by mode the pause button or is it with the door open and the start button pushed. It would be really helpfull if they have video on how to put into diagnostics.

I need to replace the door hinges. can you tell me how to get to the hinge screws?

I need a service manual, I have a parts breakdown, in self diagnostics, I’m getting error code iFO, was told by Tech. line(with customers assistance) that meant overfill, needed pressure sensor, ordered part, went back to diagnostics, first code iFO, second code i60, third i00,. What are second and third codes? I don’t have access to tech. line anymore.