Repair Help

When we turn on the washer water comes running out from the siphon brake.
the clamps are all on tight

the top burners work fine.
however the oven will not ignite the fire.
the I changed the ignitor and it works fine but the gas will not flow to ignite the flame.

SAMSUNG

THE REF FAN HAS NO POWER AND DAMPER DOOR IS NOT OPENING.

I’M THINKING BOARD ISSUE BUT NEED TO KNOW WHERE THE TEST POINTS ARE LOCATED

TX

Do you have any videos that will show how to change this water tube assembly
Part number is WR17X12301

Hello I have a question on a Maytag Washer. I’m noticing these issues:Water will not heat up

Unit is leaking and will not cycle properly I think it may be the

Samsung Refrigerator I think it may be the

FRESH FOOD SIDE IS NOT COOLING. NO REF EVAP FAN ON WHEN I RAN THROUGH THE DIAGNOSTIC.

HOW WOULD YOU SUGGEST MAKING SURE THAT THE THREE WAY VALVE IS ACYUALLY CHANGING POSITION?

I NEED SCHEMATICS TO FIND BOARD TEST POINTS FOR THE FAN ETC.

TX

I have an issue with a Washer, it’s a LG and this is the problem I am seeing: LE error code

Hi, How can I look up questions that I previously submitted?

Concerning this unit: I replaced the board (Rebuilt 2304078) near the compressor. The capacitor was leaking oil so I know it was defective. The compressor is now on but I don’t have a condenser fan or lights for the dispenser. Do you have a schematic for this unit? There are two boards left, one in the control area in the fresh food compartment (WP2304103) the other in the dispenser (WP2303843). I can get rebuilt boards for both. What one do you think I should replace next and why?

I appreciate the expertise.

Thank you,
JAN
Barney’s Appliance
Palm Bay, FL