0 votes
620 views

GE Dishwasher Model GDF530PGM0BB
stops mid cycle, all lights flashing, turning power off resets unit to normal,
run thru cycle, repeats problem

0 votes
488 views

can you guide me to locate video for Frontload Dryer to access these main control board to replace it.

  • Guest asked 1 year ago
  • last active 1 year ago
1 vote
655 views

hello, Have a side by side refrigerator and the fresh food section is getting too cold. Freezer seems ok.

0 votes
600 views

The broil and bake igniters are not turning on.
The oven chimes when I switch it to bake or broil but the igniters do not glow hot. Could the main circuit board go out? This is a very popular oven and brand. I could not find it on your website. When will you have a video on this range?

  • Guest asked 1 year ago
  • last active 1 year ago
1 vote
922 views

I HAVE A SAMSUNG FAMILY HUB REFRIGERATOR. I HAD THE POWER TO THE HOUSE GO OUT AND COME BACK ON DURING THE NIGHT. I ALSO HAVE ON OCASSION FAMILY MEMBERS NOT CLOSING THE LOWER FREEZER DOOR ALL THE WAY AT TIMES. I HAD A MESSAGE ON THE FAMILY HUB SCREEN SAYING ABNORMAL TEMP AND TO HOLD THE OK BUTTON FOR 3 SECONDS. THE NEXT DAY THE FRIDGE WAS NOT WORKING AND FULLY DEFROSTED.

I GOT A CODE 72 : ERROR ABNORMAL FRIDGE

I HAD A LOCAL SERVICE TECH COME OUT AND ADVISED THAT I NEEDED THE FRIDGE UNPLUGGED FOR 24 HOURS AND THEN SHOULD WORK FINE. SAIED THE COMPRESSOR IS FINE.

I UNPLUGGED FOR 24 HOURS AND IT DOES NOT WORK.

I CLEARED THE CODES AND THE SELF DIAGNOSTICS DOES NOT REPORT ANY CODES. ALSO THE RED LIGHT ON THE PCB BOARD IS A SOLID RED. NO BLINKING. I TRIED ALL THE DIFFERENT WAYS OF TRYING TO RESET THE REFRIG BUT NOTHING WORKED.

IT SEEMS LIKE SOMETHING IS WRONG WHERE THE FRIDGE DOES NOT KICK ON THE COMPRESSOR OR THE FANS INSIDE THE FRIDGE. THE FAN NEXT THE COMPRESSOR IS SPINNING. I VACCUMED THE CONDENSOR AND IT IS CLEAR OF ANY DIRT AND DUST.

WOULD IT BE WORTH WHILE TO REPLACE THE PCB BOARD? MAYBE A NEW BOARD WOULD POWER UP THE COMPLRESSOR AND FAN, ETC.?

ANY SUGGESTIONS WOULD BE MUCH APPREICATE. THANKS FOR YOUR HELP.

JEFF

  • jefftodd asked 1 year ago
  • last active 1 year ago
0 votes
1k views

my electrolux washer will not start the cycle.

0 votes
2k views

My washer is not cleaning my clothes properly.

0 votes
2k views

Hello I have a question on a Electrolux Washer. I’m noticing these issues: Will not run

0 votes
2k views

My Electrolux washer seems to be off balance.

0 votes
2k views

Clothing gets stuck, tub moves around a lot, bad smell, standing water.

0 votes
2k views

DDO Error, Fabric Softener will not dispense, drawer will not drain, Clothes are not getting clean.

0 votes
2k views

E91 Error, display goes blank, will not run.

0 votes
2k views

Screen is blank, E90 Error, ERR is on display, runs then shuts off, random numbers and letters on the display.

0 votes
2k views

Over fills with water, Starts to fill and stops, E32 Error.

0 votes
2k views

Will not fill, will not stop filling, E22 Error.

0 votes
2k views

Standing water, bad smell, huumming sounds, E21 Error, E22 Error.

0 votes
2k views

Humming and Clicking sounds, clothes are gray, soap still on clothes.

0 votes
3k views

Clothes will not spin out, banging sounds, boot is torn.

0 votes
2k views

Squeaking noise, will not always spin, burning smell.

0 votes
2k views

Electrical Smeel, Burning smell, runs for a while then shuts off, E69 Error, E11 Error.

0 votes
2k views

E5E Error code displaying, E43 Error, lights come on but will not start.

Showing 61 - 90 of 9k results