0 votes
3k views

Leaking water, Unit will not run.

0 votes
7k views

Display shows error codes, Missing digits, Display will not light up, No ice through dispenser, Buttons will not respond.

0 votes
3k views

Leaking water, Will not dispense water, Ice in freezer, Center strip between freezer and fridge is warm.

0 votes
3k views

Customer stated that the temperature isn’t right. Some times pre-heating isn’t working. This unit has an issue with temperature sensor?

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
2k views

board part# wp8524212 I would like to know if you have a video how to removed this board.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

Washer gets 5 min to end of the cycle, try to go on high spin for a while and goes back to min 13 or 9 depends of cycle.

  • Guest asked 8 years ago
  • last active 8 years ago
1 vote
7k views
  • Guest asked 8 years ago
  • last active 8 years ago
1 vote
3k views

Hello, My Maytag french door refrigerator control panel was blinking and the ice machine flap was clicking. After several days, the refrigerator stopped cooling. I watched your very helpful video on how to replace the HV Control Board ( https://www.youtube.com/watch?v=fwoLQdcFv1Y&feature=youtu.be). I ordered the replacement board and did the repair myself. The interface stopped blinking and the fridge is cooling again. However, now the ice machine will randomly start dispensing ice into the door with out being prompted. I’ve had to turn off the ice machine so I don’t have a bunch of ice in the door and therefore dealing with leaking (it still attempts to dispense randomly with out any ice). Please help! Thanks!

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
4k views

What is the resistant of the water temp sensor with or without water

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

CUSTOMER HAS SAMSUNG REFRIGERATOR WHICH FROSTS UP THROUGH THE EVAPORATOR MOTOR COVER. WE HAVE REPLACED DEFROST SENSOR, HI LIMIT AND HEATER, AFTER A COUPLE OF WEEKS IT FROSTS UP AGAIN.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

Evap in fresh food section solid ice, looks like no defrost. My question is what will usually fail on this model for defrost?

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
4k views

Hi there,
My customer complains that the broil makes an explosion sound and she smells gas when she uses the broil, it does not happen all the time it just intermediate, when I tested it it was working fine. This model does not have ignitors just spark electrode on both bake and broil. Do guys experience any similar issue with this model?

She also mentioned that when it happens the spark electrode sparks once and then she doesn’t hear it anymore. When I was there it sparked 2-3 times and then lit up with no issues, I was there for 30 min and when the temp when down the broil lit up again with no issues

Thanks,
Don

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
5k views

Compressor keeps shuting off, Burning smell, Comressor short cycles.

0 votes
2k views

Whining sounds, Ice forming on back panel.

0 votes
4k views

No ice, low water pressure at dispenser, No water at dispenser.

0 votes
5k views

Water leaking on floor, No ice production, Drip leak through dispensor.

0 votes
9k views

Will not produce ice, Will not dispense water, Ice build up in freezer.

0 votes
3k views

Will not dispense ice, Humming sound from Freezer.

0 votes
8k views

Leaking water, Solid chuck of ice in bin.

0 votes
3k views

No coming out gas. The igniter is working good. What part we need to be replaced?

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

LG DRYER well only click when the start button is pressed but will not start turning or tumbling and would like to know what would be my suspect components to test on this unit also would like to have a disassembly video on this particular unit

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
5k views

Opened drained and removed ice buildup. Poured hot water down drain didn’t think it drained fast enough but did drain. Tubing and nozzle in back we’re ok.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

The controls will not respond on my Whirlpool refrigerator.

0 votes
3k views

Air flow issues.

0 votes
3k views

No lights at all.

0 votes
4k views

Not dispensing ditergent.

0 votes
2k views

My washer is not draining properly.

0 votes
4k views

My Whirlpool washer will not start up.

0 votes
3k views

Water will not dispense, Ice will not dispense, no crushed ice.

0 votes
3k views

My washer will not fill.

Showing 2851 - 2880 of 9k results