Appliance Type: Refrigerator

My Whirlpool refrigerator is dripping inside.

My Frigidaire refrigerator is not getting water to the ice maker.

The center pannel on my Whirlpool refrigerator is hot to the touch

Wisemotion is a linear compressor designed and manufactured by Embraco. How do I service this ?

GOOD MORNING. THE KITCHENAID STOVE IS SHOWING ERROR CODE F2: E1 TY. THIS MODEL HAS THE CONTROL BOARD AND TOUCH PANEL POSTIONED JUST RIGHT FOR A BOIL OVER TO COVER BOTH COMPLETELY, AND THIS DID HAPPEN. I TOOK OUT THE CONTROL PANEL AND LOOKED FOR ANYTHING OUT OF THE ORDINARY, BUT FOUND NOTHING. IT SEEMS THAT THIS CONTROL BOARD IS NO LONGER MADE. CAN ANYTHING BE DONE? THANKS, TODD FROM NY.

Complaint: water leaking from the fresh food side out the front of the fridge door and ice forming on the wall between the freezer and fridge on the fridge side about 18 inches up from the floor of the refrigerator. I have not seen this before? Has anyone run into this on a GE and know the cause? I just looked up the fridge and see that there is an evaporator in the fresh food side. A frozen drain could be contributing to the water leaking from the fridge. Would this excess moisture cause the freezing on the wall between the freezer and the fridge? I did look at the fridge briefly but did not have the time to get deep into the diagnosis. I did not check temperatures yet, I will be going back on Thursday. Thanks for any advise.

Ice maker in ceiling, auger motor and also water not working at fountain center.
This house has two of these same models. Open a door and a little picture with an x over a door lets you know a switch has opened. However, on the effected model this does not occur. in diagnostics you can check the door switches/ they check as open. Interior lights operate fine when opening and closing the doors. I have gone as far as replacing the switches(thinking under load -problem). I have swapped all three boards from the back of unit as well as the display module. I have checked continuity and voltage through all door switches(3).Still no ice,water or auger.

My Maytag refrigerator is not cooling properly.I heard a squealing noise in the freezer and now I do not hear anything and its not cooling.

My GE refrigerator is not cooling properly.

The fresh food section of my GE refrigerator is not cooling.

My Amana refrigerator is not cooling properly in the refrigerator section.

Electrolux Refrigerator. Nothing against Electrolux don’t know a lot about them we do mainly high-end /built in work.
Says in the morning he gets a slushy from his through the door ice dispenser.
Besides the obvious flap/dispenser door not closing, warm air intrusion etc. any brand specific idiosyncrasies / service bulletins /kits to be aware of with this particular unit and reported problem.

My GE refrigerator is not dispensing water.

My refrigerator is not cooling.

Hi guys this refrigerator has a broken water line at the door it looks like a foam in door. Is there anything I can do to rectify this issue or repair the line ?

lg REFRIGERATOR – DOOR CAMS #Closing Cam 4430JJ2005B
Does anyone have instructions on how to replace the door closing cams on the FF section.
model # LFC20760ST/06

Can Reverse osmosis filters be used on ice makers ?

I’m pretty sure that the 180V 100uF cap is the problem as the safety overload breaker clicks on the compressor,
The cap reads Bad all day on my cap testers LC77 and “Z” meter, have you guys seen this usually being the problem or do those compressors go bad a lot? I did not have one to swap it out, the thermistor looked fine no arcing at all.

I have this bottom mount freezer that I removed the freezer door and big basket to
steam out the drain pan after replacing the drain update. I didn’t remove the rails. Now the door doesn’t seal tight on the right side. With the front off I can see that the track is not flush like on the left side only when the big basket is installed.
Nothing seems to be preventing the rail from going all the way back. I’ve made sure the gear teeth are are the same
and even with the rails extended. Am I missing something or is it just a bad rail?

We have a Ge refrigerator is the water line in fez door replaceable acceptable. We took dispenser apart looks like waterline is in the white tube at dispenser

Can you get me a tech sheet for this unit. It is frosted up and I want to be able to do a forced defrost to check and see if jazz board is bad.

Running water at fountain center at approx. 15min. intervals. Shut I/M and problem stops. Anyone? Older refrigerator.
Thanks,

I replaced the ice maker in this Amana refrigerator. Since replacing, cubes are not hardening, ice is clumping in the bin because water not completely frozen when harvested. Temp in freezer is zero. The Amana ice maker part number changed to the DQ model. I transfered over all the parts to the new model. I’m thinking the harvesting is happening to soon or the heater is on to long. The ice maker did not harvest any ice in the first 24 hours and the cubes were frozen toward the evaporator but not completely frozen to the front of the unit. Any ideas on whether I should try a second ice maker or what to look for? Thanks for your help.

This is a new one for me. The above fridge is a french door type with the TV monitor, Pandora, and such. Problem is the drawer above the freezer has no lights shining that would turn on when the freezer were to be opened and the touch panel on this deli drawer is unresponsive. Everything else is working in the fridge.All other lights and it is cooling. Best buy told the customer that the rear main control board would need to be replaced. What say you? Thank you for any advise.

My Whirlpool refrigerator is not dispensing water.

I have a defrost error, refrigerator temps fluctuate from 36-57 degrees.
Where can you guys point me?
Thanks,

The holder bracket that is mounted to the left or outside wall that holds the auger motor plate has broken and doesn’t show in the parts breakdown.
Anyone out there to help me?
Thanks,

I FEEL THE AIR VENTS. NOTHING.
THE REAR COILS ARE NOT FROZEN.
I REPLACED THE FREEZER FAN.
I REPLACED THE MOTHERBOARD BASED ON ADVISE FROM REPAIR COMPANY.
THIS THING IS EXPENSIVE
I WANT TO CORRECT THE PROBLEM.
THE FANS ARE MOVING.
I ORDERED THE CONTROLLER BOARD FROM AMAZON.
INSTALLED.
IN TEST MODE THE AIR MOVES.
OUT OF TEST MODE THE AIR DOES NOT MOVE.
I HAVE NEVER HEARD OF FREON LEAK EVER.
I DONT KNOW \
ADVISE

The center panel of my whirlpool refrigerator is hot to the touch.

The coils in the freezer section of my whirlpool refrigerator are frosting up