Repair Help

GAS DRYER NO HEAT THERMAL FUSE IS GOOD -IGNITER GOOD HOW DO I TEST HI LIMIT OR OTHER TSTAT
DO YOU HAVE A VIDEO ON THAT PLEASE ?????

I was out on this once, I reset unit, now the only time it works cust. has to reset it. Is it the I/m. Thanks you for your help. thanks always Jim.

I have paperwork that indicates the resistance value should be 97 ohms, at the molex connector unplugged from the inverter. The led was blinking 4 times for a mode shifter error. I installed another mode shifter off of a machine that worked but had bad bearings. It had a reading of 63 ohms. The unit still won’t agitate, and I still have the error code. I swapped the inverter out with a known good board with no change. Do you any ideas why the mode shifter would work on one and not the other? What is the margin of error, for the resistance value, of the mode shifter coil?

Icemaker is not making ice
Checked temp in freezer ok

all the fans are working the compressor is running . no frost on evap coil and black soot on the inside walls of the fresh food compartment Checked evap coil no sign of burning wires or defective defrost heater and no sign of Freon leak The refrigerator is only 2 years old Would appreciate some help

I had read, in the past, that the time the system takes to equalize can indicate the problem in the sealed system. Is this the case, and if so can you elaborate?

THE UNIT WILL RUN THROUGH DIAGNOSTICS AND EVERYTHING WORKS. THE UNIT IS CYCLING ON AND OFF UNDER NORMAL OPERATION. I’M THINKING EITHER THE BOARD OR THE TEMPERATURE SENSOR. I NEED TO TEST THE TEMP SENSOR AND FIGURE OUT THE TEST POINTS ON THE BOARD ITSELF TO DETERMINE THE ISSUE.

THANKS

Customer called in and complained that they have had the hub assembly replaced pt# W10820039 and it worked about 4 times and was stripped out again. Just asking if anyone else has run into this as the part is not in stock with my local distributors and that is unusual. We have not seen this before.

This freezer section thawed , then rebooted and cleared has worked ok then showed h1. then before it defrosted started working again.

Refrigerator is not running.

Samsung, is not running no controls, nothing. unit does not have wiring diagram, could you send wiring diagram with some troubleshooting with it. thank you. Jim

the unit shakes baldy.
the unit is empty and I get the UL error .
I’ve looked under the unit and don’t see anything loose.

My Viking range will not heat up.

My Whirlpool refrigerator seems to be off balance.

My Bosch dishwasher will not drain.

I have a Whirlpool Stove that is not working

Problem with a Hotpoint Refrigerator

Refrigerator is not working right

I have a GE Refrigerator that is not working

My Maytag dryer will not heat.

The Plastic piece is cracked on my Maytag washer.

My LG washer is not functioning properly.

No light

Issue with Samsung Refrigerator

Having an issue with a Stove

My Viking dishwasher is making grinding noises.

I have an issue with a Dryer, it’s a Samsung and this is the problem I am seeing: Heater receives no power