Repair Help

My Frigidaire stove is not heating.

My Kenmore washer will not start.

My Whirlpool dryer is not heating.

My Kenmore dryer is not heating where do I start ?

My Whirlpool dryer is not heating.

My Whirlpool washer is leaking.

My Kenmore washer will not start.

The touchpad buttons on my Frigidaire stove are unresponsive.

My Whirlpool refrigerator is leaking.

My Whirlpool dryer starts up but will not tumble.

My GE dishwasher is not getting dishes clean enough.

My Whirlpool dryer will not tumble.

My Maytag dryer is tumbling slow and squeaking.

My electric Samsung dryer is not heating

My GE oven is not heating.

My Maytag washer is leaking water from the front, any suggestions?

Some of the buttons on the touchpad of my Whirlpool dishwasher are unresponsive.

The door on my whirlpool dryer will not stay shut.

My Kenmore dryer will not start.

I HAVE AN LG DISHWASHER LDS4050WW WHEN YOU PUT ON QUICK CYCLE IT STARTS AT 1 HR 24 MIN WASHES FOR A FEW MINUTES THEN JUMPS DOWN TO 5 MINUTES AND DOESN’T DRAIN. I THINK THE DRAIN PUMP IS OK BECAUSE I CAN CANCEL AND ALL THE WATER GOES OUT. JUST RECENTLY IT STARTED HUMMING A HIGH PITCH NOISE MY WIFE SAID IT HASN’T DONE THAT BEFORE DOES ANYONE KNOW WHAT MY PROBLEM MIGHT BE. IT DOES HAVE SMART DIAGNOSTICS BUT I DON’T KNOW HOW THAT WORKS.

Any idea what error this could be ?

This one has me stumped. Machine is giving E21 “Water not pumping out fast enough” error. Starts by pumping out at a trickle and occasionally will “kick in” to full flow. Pump sounds like its sucking air/air locked. Will drain properly every 4th or 5th attempt. Removed and checked all hoses, found all to be clear. Removed tub-to-pump boot and looked up with mirror to bottom of tub and could see the inner tub with no obstructions. Tried running pump directly with test cord to rule out low current from main board and tried new pump with same results. Any Electrolux experts out there with suggestions? Greatly appreciate any help

Hey guys, anybody worked on this Italian made whirlpool washer LHWOO5PQ4 serial
cat2611315? Its 240 volts ? Not starting has 240 volts

The items on the top shelf are above 40f and the items at the bottom shelf are freezing. I tested the heating element and it’s good, fan seemed to have an intermittent issue since the bottom was iced over, so I replaced the main control board since kitcheaide fridges seem to have this issue and it worked for two weeks now it’s doing it again. Please advice.

     Need Help on a GE  Dryer, This unit will only run for Five minutes an then shut off,

You can Press the start Button and it will Start back up, but you can set the Control to
Air only and it will then run Normal. Could this be in the Control or the Thermister
problem ? You can set the control To No heat and the Dryer will then
Run Normal. I am thinking it may be a bad thermistor or Main Control, Need your help.

I need a viedeo on how to take the freezer section appar to install a evaporator motor

Working on this dacor wall oven originally giving a u60 error, cooling fan, installed cooling fan and we are still getting the error. Can anyone assist us with a tech sheet and some direction where to go next? Thank you.

We would appreciate some advice on this unit.
A few weeks back it was faulting out with an F71.
We replaced the MCU it ran fine for the few weeks.
This is a well used unit in a care facility.
New complaint “not spinning enough” It will run thru cycle till final spin, 13 mins left in cycle. It will spin slowly and not advance past the 13 mins on display.Not showing a fault code.
It will spin in the test cycle.
Any advice would sure be appreciated.

My Maytag washer keeps locking and unlocking , will not finish cycle.

My Roper washer quits mid cycle.