Repair Help

My LG stove is getting F11 and F3 error codes also the touch pad is unresponsive.

My GE refrigerator is not cooling in the fresh food section.

My Maytag washer is not draining.

My Kenmore refrigerator is not getting cool in the fresh food section.

My gas Kenmore range will not preheat.

My Frigidaire refrigerator is leaking water on to floor.

LG top load washer goes through the wash and 2-3 times spins slowly during wash. Centrifical force sends some water over top. Not sure what to do about this since it is part of the computer software?

This washer is driving us crazy it works in all manual test modes
but during wash it seems to be stopping on the final spin and the lid lite is blinking
Error code F7 E1 drum speed sensor? The error code F7E1 are in memory
repair history…
*replaced the actuator
*oil leaked from gearcase, replaced case and belt
*replaced lid lock
everything works in manual test mode.
Calibration runs very short.

What would make one of the hot surface lights on the stove top stay on even the the burner isn’t hot?

My Maytag dryer is making a loud squealing noise.

My Whirlpool dryer is not heating.

The back left burner on my Hotpoint stove is not working.

The ice maker in my Maytag refrigerator is not working.

How many times do you have to push the buttons in the right time

GOOD MORNING. I LOOKED AT WASHER, CHECKED THE PLAY IN TUMBLER AND IT WAS VERY BAD. I BELIEVE IT IS A BAD BEARING, AND THE PARTS AND LABOR FOR THESE JOBS, USUALLY MAKES THE CUSTOMER PURCHASE A NEW MACHINE. I WAS TOLD HOWEVER, THE MACHINE WILL STILL COMPLETE A LOAD, WITH A LOT OF CLUNKING. COULD THIS BE SOME OTHER EASIER REPAIR? THANKS FOR YOUR TIME, TODD FROM NY.

Can you tell me the button dance to reset fault codes. The owner took the info and cannot remember where he put it. Lots of help not. If you could tell me the buttons I would greatly appreciate it. Thank you for all your help.

Trying to fix a GE Washer that the Agitator will not spin. Could you point me in the right direction of how to fix this?

This top load washer goes through the wash and 2-3 times spins slowly during wash. Centrifical force sends some water over top of the tub . Not sure what to do about this since it is part of the computer software. Thanks in advance

Gas dryer igniter will glow for about 8-10 seconds the click and will not light. Could not find anywhere what the resistance should be on the igniter. Any suggestions on what else could cause this?

Ge dryer that will not stay running after you turn the start knob. If you hold the start knob over the dryer will run, but as soon as you let it go, the dryer shuts off. The start switch has been replaced. Does this sound like a motor issue or is it possible that the switch to the pulley is malfunctioning? Any advice would be great. Thanks in advance.

I have a LG French Door Refrigerator with a few different symptoms 1) Its not cooling 2) Its making noise 3) It has frost build up in freezer section. Any help is greatly appreciated.

TPS24BPDABS

Water valve energizes every 15minutes sends a few ounces of water through the fountain center dispenser. Shut off ice maker and problem goes away. This unit is 15 years old.
Anyone seen this happen on the GE products? Thanks in advance

GE Profile french door unit, the mullion between the 2 fresh food doors gets sweaty / condensation on it. Turned the energy saver button off as instructed but it still doesn’t stop the condensation on the mullion. Also the ice chute get ice build up in it ( not frost like when a door recess goes bad, I mean solid chunks of ice.) Any suggestion to this ?

I have a Maytag 4000 Series Washer model# MHWE450WW01. This started about 2 weeks ago. I had an F71 error code. When I hit the power button I’d just get 3 beeps, no display. Found a Youtube video from an appliance tech who said F71 was a motor control board. Replaced the motor control board and everything seems fine until I ran a whole cycle and had wet clothes at the end. Everything seems fine except I get no high speed spin. Thought I might have got a bad board so I contacted partsimple.com and they sent me another board. That didn’t change a thing except to confirm the board was ok. I then replaced the control board. That didn’t change anything.

Here’s where I’m at now: In diagnostics it will spin at full speed with the C08 diagnostic test which tells me I don’t have a mechanical problem like a slipping belt, motor etc. During a normal wash cycle it will not spin at high speed with or without clothes in it. The door locks fine, door lock indicator is lit and door won’t open. It fills to the normal level and drains fine. Spin light comes on but the drum rotates at wash speed. It acts like a load balance problem. The drum rotates one way, stops, rotates the other, then the drain pump comes on and it tries to spin but then stops again, rotates one way then the other like it’s trying to balance the load. I can’t locate the balance sensor (if there is one). Any help would be appreciated.

The evaporator coils on this unit were so frozen up they busted the fan and fan housing. I have everything defrosted off, checked the heater but not sure what the resistance should be. Do you guys have lots of trouble with the boards on these, or is this more than likely the defrost sensor?

I AM TRYING TO ORDER THE HEATING ELEMENT AND THE DIAGRAM SHOWS I HAVE TO BUY THE ENTIRE HOUSING. THE CUSTOMER WAS SHOCKED AT THE PRICE, SO I CALLED A LOCAL SUPPLY HOUSE AND THEY SAID THAT THEY CAN GET THE RESTRING COIL THAT IS MADE BY FRIDGADARE. DOES THIS SOUND CORRECT AND HOW DO YOU MATCH THE ELEMENT? THANKS, TODD FROM NY.

Customer states this unit is down to 17 degrees below zero and stuff is frozen rock hard. This is a freezer only unit. States it does not change temperature when adjusted warmer. Just stays at -17 degrees. Serial number is . I don’t normally work on Subzero. Any suggestions on what I should be checking will be welcome. Thank you

I Have a GE Refrigerator and the Evaporator Coil On the Fresh Food side Keeps
Freezing Over, I have Change out the Thermister and that did Not Help, Both Fans
In the fresh food section is Working, What else should I Try?