0 votes
3k views

door wont lock, no start, DE error code.

0 votes
3k views

Will not start cycle.

0 votes
3k views

Cosmetic damage.

0 votes
3k views

Will not start cycle

0 votes
3k views

Not running.

0 votes
3k views

Noisy during spin cycle.

0 votes
3k views

Very noisy during spin cycle

0 votes
3k views

Noisy or vibrating.

0 votes
3k views

Rotor is physically damaged.

0 votes
3k views

Will not complete warm water cycle

0 votes
4k views

Rattling and buzzing sounds during drain.

0 votes
3k views

I checked ALL of the “how to” websites looking for this particular part # to change out. I found NOTHING !!!
The complaint is that the dishwasher ONLY pumps out water. It does nothing else. I checked out the possible problem(s) and found that it is or could be a bad water sensor. Especially with this model number.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
2k views

The ice maker in the left hand French door thermister temperature is 16.30 on test #36. There is good air movement through the upper vent and it filled properly on the fill test. I have all the technical data. So what I need to know is does this mean that the ice maker is bad or the door board or something else?

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

We have came across many led issues on some of these refrigerators. Some lights won’t come on and when they are replaced they still won’t work even by replacing the boards as well. Please help

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

Not filling properly.

0 votes
3k views

ERROR CODE.

0 votes
2k views

Will not run.

0 votes
3k views

Uneven baking in convection mode.

0 votes
3k views

Uneven baking results.

0 votes
4k views

LG dishwasher will intermittently show a drain error code. When this happens the machine will just sit and do nothing. If restarted it will run the cycle.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

samsung dryer no heat, i have check heater element, high-limit thermostate,thermal cut-off, thermal fuse and thermistor. they all have continuitie. what else is there to look for. thank you

  • Guest asked 8 years ago
  • last active 8 years ago
1 vote
4k views

Hello, we just bought a dryer that runs fine then it just stops and sits there and the power button flashes. and as soon as you hit start again run runs fine any thoughts?

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
4k views

The evaporator in the refrigerator side is constantly freezing and never defrosting. I replaced the thermistor and all boards, please help

  • Guest asked 8 years ago
  • last active 8 years ago
1 vote
30k views

The fridge temp is to high. I found on the lower left side of the fridge a small block of ice, where the vent should be. I thawed out the ice turned the fridge back on, and felt no air flow ( either wat ).
The top left side vent was blowing cool air. Not a lot of air flow, but I could feel air moving.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

I have no power to control to control board so I have no oven functions

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

I performed the ice maker cycle and fill test and it filled properly. The ice maker thermister test showed 16.30 degrees. What is the normal ice maker thermister degrees? Is this a bad ice maker or door board failure?

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
3k views

I need a tech sheet.

  • Guest asked 8 years ago
  • last active 8 years ago
0 votes
4k views

No bake or broil, Wrong temperature.

0 votes
3k views

No bake or broil.

0 votes
3k views

No display, No power.

Showing 2731 - 2760 of 9k results