Repair Help

When put on normal wash the interface push buttons the lights go on. If you it cancel pump runs to drain the unit. Then put normal wash and it start the lights are lit up for right cycle 5 seconds later they will all go out. Like there is no power on the unit? My question is it the interface board or the control unit?

PARTS DIAGRAM, SCHEMATIC AND TROUBLESHOOTING INFO. THANKS

so the compressor is dead.
can you please tell me how i change it?
maybe a video instructions

About a month ago, I replaced the I replaced the ice maker and water valves. Everything worked until yesterday. The water dispenser stopped. Nothing comes out.

We had a little problem with the freezer or the door was open for a while that frees up the evaporator fan be defrosted it and everything’s working fine however we realize now that when we push the cube on the ice dispenser crushed ice comes out .
And when we put crushed ice crushed ice comes out as well

Miele dishwasher machine not draining I open up the inside I checked the propeller for any blockages there isn’t any he tries to drain I hear the pump trying to drain but the water is just not going out

I’ve tested the air flow with a meter it is poor I’ve tested the igniter everything else inside is working fine there was a tremendous amount of lymph build up inside the machine cleaned everything out and still getting poor airflow reading

The washer only leaks when in the spin cycle. When washer goes into spin it will start leaking from the center where the transmission goes thru the tub and it makes a grinding noise. If I replace the spin bearing will it also stop the water from leaking. Thanks Ricky

The board on this unit was flicking off and on and constantly beeping. Will do this while the unit is idle. I changed the control, everything seemed ok, get a call and now the board says needs service and is beeping. Any ideas?

GE washer board flashing 4 times. Never seen this before. Any suggestions ?

it will drain.
how ever when it comes time to agitate or spin it make a rubbing sound.
i have tried to turn the agitator by hand both ways one way turns easy the other is hard and fells like its off track .
please advise

What causes this problem?

Everything else works but there’s no water coming into the machine. I have checked the water hose and there is water in the line I have tested the water inlet valve for continuity I’m getting 0.808 ohms of resistance does that mean the water inlet valve is faulty and if it is good what else can be the problem thank you

Have issue with Scotsman ice machine. Contactor closes pump runs compressor starts runs no fan I think unit tripping contractor opens due to hi pressure. Check one side fan power from contractor and the other from main board not getting power from main board. The board is very expensive does anyone have information on unit all help appreciated

I’m working on a Thermador range issue is with the top burners all igniters are working fine but the gas takes very long to open ( can’t hear it) , same issue with the griddle except that on this one you can see the spark going off before the gas comes on ,no flame , it looks like out of sync. I check the burner holes all are clean ,the issue is the gas is not heard until several clicks later. Any ideas or a manual for this one?

I asked for info on replacing tranny on this unit and i got info on how to use the unit? I need service manual on this beast>

I am going to replace the transmission on this combo laundry unit and would like to see a vidoe on it. And or down load me a service manual on this unit Thanks in advance

I got a new ice maker with wiring harness installed it. 24 hrs later open the refrigerator no ice dropped into the bin. The ice maker is making ice but just stays in the tray. you can see the ice in the tray. Do you know if there having any problems with this refrigerator? I have never installed ice maker and not have it work. They always have power on them.