Repair Help

My Kenmore washer will not spin out.

My Kenmore dryer makes a very loud high pitched noise when in use.

My Whirlpool refrigerator is not cooling in the fresh food area.

My GE refrigerator is not cooling properly.

My Kenmore washer is showing “SUD” & “F02” error codes plus has bad vibration during spin.

My gas whirlpool dryer will not heat.

My GE dryer suffered flood damage and now it will not heat

My Whirlpool washer will not spin out.

My Maytag dryer is getting power and making a clicking noise, but will not start.

My Lg washer randomly powers on by itself and makes beeping noise.

My Samsung dryer is not getting any heat.

My Samsung refrigerator will not cool properly

My Bosch dishwasher will not shut off, it continues to run.

Samsung washer leaking underneath.

Lg washer.Dial wont work only runs on one cycle.

My Lg washer is leaking hot water.

My gas dryer is not getting any heat.

My door wont latch shut on my Samsung microwave.

Unit will spark but wont fully ignite.

I have a gas dryer, the drum will turn but unit will not heat.

Unit is not cycling properly , keeps spinning and stopping.

The door of my washer is locked and I cannot get my laundry or the water out of the unit.

The unit was freezing at the bottom and not cooling properly.

I could not get my washer to go into the spin cycle.

THIS IS A MAYTAG STACKABLE WASHER DRYER COMBO. THE AGITATOR WITH SHAFT INCLUDED FLOATS WHEN THE WASHER FILLS WITH WATER. I LOOKED AT THE SPLINE AND IT SEEMS TO BE IN GOOD CONDITION, NO CUTS OR SCRATCHES. IS THIS A BEARING PROBLEM AND WILL IT REQUIRE A SPANNER WRENCH? HELP! THANKS, TODD FROM NY.

I have multiple issues with this refrigerator. The unit is frosting and not cooling and the ice maker is not working. The display has three error codes. Do you have any repair videos on this model ? Thanks in advance….

oven turns off

Whirlpool Cabrio Customer complaint it doesn’t complete spin cycle, water is pumped out but clothes are still wet. They start spin cycle to finish load.
Error codes:
F7E7 – Motor unable to reach target rpm
F0E2 – Over suds
F7E1 – Basket speed sensor fault
Unit agitates and spins in diagnostics. There is no clothes caught between tubs. There were no flashing lights when performing the tachometer verification mode. Wires and connections were good.
Not sure if this is a shifter problem or main pcb problem?

I went to service a Frigidaire Infinity washer today, I cannot get the unit to go
Into the Diagnostic mode, Only two lights on the Console will light up. I replace the Control
Module and still get the same results, need some Help or direction..