Repair Help

My Whirlpool washer Is not spinning out all the way.

My LG washer stops mid cycle. Not pumping out water.

The door on my Kenmore dryer will not stay closed.

My Samsung washer is filling very slowly

My Bosch dishwasher will not cycle through.

my Bosch dishwasher is leaking water.

My GE refrigerator is not cooling.

My front load Maytag washer will not start.

My portable Maytag dishwasher will not drain

The icemaker in my Kitchenaid refrigerator is not working.

My Electric GE oven is not heating.

My Maytag washer is not spinning.

My Maytag dryer makes a clicking noise during the cycle and smells like smoke.

My Kitchen Aid wall oven microwave combo, that the halogen bulb in the microwave keeps failing every six months. Has anyone seen this situation before?

These videos of subzero 511 doesn’t show.

https://www.appliancevideo.com/?cat=&find=511&post_type%5B%5D=post&post_type%5B%5D=premiumvideos&post_type%5B%5D=fromthefield&post_type%5B%5D=embdvideo

1. Dishwasher does a good job of washing dishes
2. Problem is that the control buttons on the top edge of the door do not illuminate making it hard to read the buttons.
3. No buttons are illuminated when the door is first opened to select a wash cycle.
4. Selecting POWER or any particular wash cycle causes the outline on the button to illuminate but the text remains dark

This dryer does not heat, plus in any cycle it will shut down after 2 minutes of running. The heater is bad, but not sure if the other problem is the most likely cause of the motor, or if it is the board. Any ideas?

Your 511 videos are showing up.

I replaced the water inlet valve and the dual inlet valves due to the failed continuity readings (I actually measured the wrong switch, so I have an extra valve now grrr).
I waited over a week and still no ice. I also felt no water in the tray, so I thought the ice maker water line was clogged. Checked that by blowing air through it and it was clear (still no ice).
Put the fridge in diagnostics and ran the ice maker through a cycle and it ran fine up until it needed water. The service test 25 never showed a Digit 1 other than 0. Tested voltage to the solenoid and nothing there. The door water valve gave 122v.

Now I am at a loss to determine if it is;
-the wiring harness
-the ice maker
-control board.

I thought it would be worth the $25 to ask you how to go about testing for which of the above it could be.

Thanks for your help,

Tom

So from what I gather this unit was damaged by a storm power surge. When you open the door there are no lights, light bulbs are ok. The ice in the door bin will not dispense and ta majority of the time it doesn’t make ice. I am also concerned that when the fridge door switches are held that I do not hear either the evap fan or the icemaker fan. Please advise.

Replaced mag cap and diode still no heat what else could it be this is a built in mw it model 401.85053010 ser 142mm00673

I’m repairing a ge monogram 10 yrs of age, I found a capacitor to be bad, this capacitor is located in the back of the unit at the top where the compressor compartment is located. I Haven’t been able to lpocate this capacitor on any site the only capacitor I can locate is the one located in the front of the compressor compartment that is a small black rectangle which is still good and I don’t require. The capacitor I’m searching for is silver 4 to 6 inches in lenth has 3 prongs and is a cylinder in shape. Would you know where I could find this part

I can’t see any way to get to change the auger motor on this unit. There isn’t a opening on the bottom as the older styles had. Any ideas or videos you have would be wonderful.

The right door on this refrigerator pops open when the left door is closed first. I replaced the door cam, part #12028505ap but it did not stop this from happening. I have been telling my customers to open both doors and close the left door first in order to insure both are doors are sealed properly. I have not found an answer on the web. Hopefully your repairmen have found a solution.

Thank you!
Mel
My Appliance Repairman Inc.

I do not see a category for Compactors. Are there no resources for Broan Compactors? I see you have a video for a Kitchenaid. It is not much. All it offers is a suggestion that is in the use and care manuals. No other complaints or remedies are given. BTW ; Whirlpool literature states that the level needs to be at least 1/2 full not 3/4 full

I have my own curriculum on Broan Compactors and Whirlpool. All 12″ wide Broans NL in production nor is the 18″ Viking (Hobart-KA). The Broan Elite 15 is being used by electrolux. Do I need to search under that brand?

Now a days I only instruct on Whirlpool and Broan and only for a few days of the training program.

My Maytag dryer is making a loud noise when in use.

My GE oven is not heating.

The compressor its not working so i check power at the terminals and it has like 28 vac, i replace the 2 control boards on the back and still dont work, where else can i check, i also check the capacitor and its good and it doent have a start relay, it look like it start with one of the control boards

Samsung freezer is over freezing and making frost on inside of whole freezer. I/M does not work, and it actually looks like the freezer door is not being shut all the way, but they swear it is pushed shut every time. Any ideas? I know this particular I/M has a sensor on it, could this be the issue as well?