Repair Help

How do we replace the two tracks that hold the upper rack? Is there a video that shows this? Ours does not have visible screws. Please advise. If you have a video, we would definitely subscribe to watch that video.

I thought it was odd that our stove tripped a breaker, as soon as I reset it, it seemed fine. What should I check on it to ensure it doesn’t keep happening?

My husband is trying to figure out our refrigerator problem. He says he ohmed the compressor and it is good, and main board seems fine as well. He spent all day yesterday checking the fans, the heater, timer, and thermostat. What are we missing? Really don’t want to buy a new one right now. Please help!

The dryer is not producing heat. I took the heating element out and the coil doesn’t seem broke anywhere. Should I still replace it or is something else causing the problem?

Thank you
Dustin

So I have a Frigidaire refrigerator from 2009 that seems to no longer hold a steady temp in the fridge section and even when I turn the thermostat to make it colder it will turn on for about one minute and then shut off and then 3 minutes later do the same thing over and over again. There is no ice build up in the freezer and that is holding a steady temp of around 20 degrees but will not get colder than that. The fridge side will not get colder than 40 degrees and will flutcate between 40 and 45 depending on how much we open the door. Even the coldest setting on the thermostat there in no change in the fridge temp or freezer temp as well.

Can I turn my freezer to power 0 and leave the refrigerator part on in order to thaw out the frozen drain line and pan? Hopefully that way I don’t have to remove all the parts like in the video.

lights, fan work compressor does not cool

How do i remove top to replace the light socket on the top of the inside of the machine

Hi, I would like to follow the repair instructions from this video: https://www.youtube.com/watch?v=k1KEfcNfcMo

But I do not know which tools to purchase, could you tell me the name of the tools used?

Thank you!

Is this something fixable? It still seems to be cooling for the time being but it’s annoying.

washing machine has error code and will not work. Couldn’t find what it means or what we’d need to do to fix it.

The mfr. date is 01/2004. Compressor runs, but does not cool. Would it be cost affective to repair? Not sure if there is a leak, bad starter or the compressor is bad. It is a top/bottom style, stainless doors, medium in size.

Fans are working, door switches are working. Compressor has good continuity, resistance values are 5, 7 and 11 ohms. I’ve replaced the PTCR relay and overload. Run capacitor measures 12 uf. When I plug into wall, the compressor tries to start and immediately shuts off. I hear a clicking on the mother board; both, when powering on and again after unplugging. Is there a way I can test the mother board before purchasing a new one or does the clicking indicate a bad component on the board?

This model has a single digit temp. control for freezer and fridge – each has “colder”, “warmer” buttons. I don’t know how to get into diagnostics mode; but, would this tell me what is wrong?

re: https://www.youtube.com/watch?v=-N39ZXZTWwc

Hi Sean, Your video, referenced above, worked perfectly with my machine. All of the diagnostics presented no problems, however, I felt that my machine took longer to drain than yours did in the video; but that’s the problem with my machine: my clothes won’t spin out on most cycles. I usually have to run my laundry through 2-3 “Drain & Spin” cycles before the clothes are spun out sufficiently enough to put in the dryer. Any suggestions would be greatly appreciated.

Thanks,
Terri

Insinkerator Badger

Serial # SJ3751348, built in Sept 1999. I cleaned a ton of dust off the coils first. Still won’t get cold. The fan motor is working and airflow is coming into the fridge and freezer. I hear a clicking noise coming from the plug on the side of the big black pot with copper tubes coming into it. Every 3-4 minutes I hear an initial “click”, then nothing happens for about 1 minute or so, then another “click”. Sounds like a relay opening and closing, but nothing else happens.

My GE oven doesn’t seem to be cooking correctly. It beeped like it preheated, but when I put dinner in last night it didn’t cook it. Hours later it still wasn’t done. Burners on top work fine, checked to make sure it was getting gas. Maybe a thermostat?

do you think the 25 amp fuse would be the most likely of the problem?

maytag epic front loading washer will not spin on high. door knock works. drains fine. spins but never goes into high spin.

I’ve noticed that the top drawer fills with water slowly after a wash cycle. The bottom drawer is fine. If I don’t run it for a while, the water continues to fill. I’ve read that it could either be the water inlet valve or the drainage hose. I believe that the drainage hose is positioned high enough with a loop such that water can’t come back in.
In my debug mode, I’ve since shut off the water source into the dishwasher and I’m hoping to wait a few days to see if the top drawer continues to fill up.
Are there any other tips that might be useful? (I’ve watched the YouTube video for repair of the inlet valve).
Are there other troubleshooting things that I can do to narrow in on the problem?

Thanks,
Jon

My garbage disposal hums -but doesn’t work – there is nothing lodged in the system from above – I have used the wrench and can easily spin the disposal from below in both directions … but when I turn the disposal on, it still just hums and doesn’t turn – is the motor burnt?
The Brand is an InSinkErator – Badger

Thanks
F

Model # PFSS5PJXCSS LED light not working. What powers the light?

Burner comes on for 10 seconds and cuts off. Clothes never heat up enough to dry.

It gets to the spin cycle and stops

As far as I can tell, there is a fan in the freezer that when the door is closed, it starts to spin and gets loud. When the freezer door is opened, it stops. There is also lots of ice starting to build up on the walls of the freezer.