My dishwasher top turning arm is not moving during the wash. EDW51000N00B13 VL709863B GE Eterna Series
- James Buchanan asked 7 years ago
- last active 7 years ago
I need to remove and replace the control panel on my GE microwave model JVM6175EF1ES. I have the part
- Harley Clark asked 7 years ago
- last active 7 years ago
Samsung refrigerator the flex zone dwarer wire harness is popping out of the side rail. This is causing the door not to close correctly. Also need the part number for that wire harness.
- Guest asked 7 years ago
- last active 7 years ago
Any bulletin related to refrigerator evap making noise or improper cooling?
- Guest asked 7 years ago
- last active 7 years ago
Customer said they saw a flash on the bottom part of the freezer when they open the door.
and ever since then the ice maker is not working if I push the lever on the door to the Spence ice the flap will open but the edge of food will not turn and the unit will not make ice.
The unit however does dispense water
- Guest asked 7 years ago
- last active 7 years ago
My KitchenAid Kuds35fxss9 control panel has become unresponsive.
- Gary Williams asked 7 years ago
- last active 7 years ago
My kitchen aid dishwasher is flashing “F1” & “E2” not sure what it means or what to do.
- James Buchanan asked 7 years ago
- last active 7 years ago
Hi my kitchenaid microwave went completely dead on me after the door mechanism got stuck. I was able to release it no problem and the door opens and closes perfectly but the unit is dead as can be. Checked the breaker and it’s A-Ok.
- Gary Williams asked 7 years ago
- last active 7 years ago
We have a one year old GE dishwasher model GDT 655smjoes. All of a sudden there is no power to the unit. I’ve checked the circuit breaker and the power is on but no sign of any power in the unit. Any suggestions?
- Harley Clark asked 7 years ago
- last active 7 years ago
I have a Samsung Refrigerator w/Ice Maker; the ice maker continuously freezes up; I have searched online and it seems to be an endemic problem; any fixes out there or do I need a hair dryer in the kitchen?
- David Sutton asked 7 years ago
- last active 7 years ago
Hi.
Please help to diagnose GE Monogram ZISS480DMAS.
The display panel is off.
What voltage supposed to come to the display?
I am getting 56V from main board.
Thank you.
This is my second request.
Please respond ASAP.
So far there is no video on this model.
Could you please call 8182664804, 8282664805
Or email at vladatk@gmail.com
Also would like a video how to replace display board.
- Guest asked 7 years ago
- last active 7 years ago
- Guest asked 7 years ago
- last active 7 years ago
this is a 2-4yr old top load belt driven washer. Seems to agitate ok. Drains ok. When entering spin cycle the wash plate spins very fast. Then the tub starts to spin faster & faster. So fast that it starts banging against the sides. This is with no clothes in the tub. I think it would take off if I didn’t pull the plug. This is the 3rd machine similar to this one that I have run across doing this same thing. The other machine made the same way was a Maytag model # MVWX655DWO. They all have a black actuator, not the common brown one. This also happens when you try to recalibrate the main control. Cant let it finish the recalibration mode, its starts spinning so fast out of control. This is not an off balance problem. This is a case of wash plate can run very fast & tub can spin way too fast.
- learnnowjim asked 7 years ago
- last active 7 years ago
Does this unit have any service flashes or job pointer concerning the bake burner and spark ignitor kit .This is a DSI system? The gas ports are clean. The oven has run for years with out the Ground supplied through the outlet. The wiring is good. No bare insulation.
Is there a service manual available?
- Guest asked 7 years ago
- last active 7 years ago
My Kitchenaid fridge’s control panel won’t turn on. If I press the On/Off button, it flickers briefly, but then goes out again.
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
Samsung ice maker ntgt001ta1 fills with water, frezzes but will not dump
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
Hello, I have a front load Kenmore that won’t spin or agitate. Water comes in and drains out fine, the washer stops in the middle of the cycle when it won’t spin. I’ve checked the drama of check the bearings of check the belt I’ve checked the Springs, everything looks mechanically okay. I’ve done some online research and it seems that a motor coupling could be the problem, but it looks like they’re only motor couplings on top-loaders. Can’t find anything on mine, front loader 417-411222410
- James Buchanan asked 7 years ago
- last active 7 years ago
complaint, only portions of numbers light up. Oven works ok. If you set it for 325F , part of the 3 & 2 is not lite up. Whats going on?? Is this some type of error code??
- learnnowjim asked 7 years ago
- last active 7 years ago
This Unit was violently Shaking, I replaced the Washer Suspension Rod Kit, W11130362
It still Shakes, It seems to have a Problem Spinning up also.
Ideas?
- Guest asked 7 years ago
- last active 7 years ago
It has power the drum will not spin
- Patrick's Appliance Service asked 7 years ago
- last active 7 years ago
Im having issues with condensation build up behind the icemaker compartment inside the refrigerator room. I know previous models had the same issue but the kit helped with the problem. Is there anything new for these models?
- Guest asked 7 years ago
- last active 7 years ago
My samsung washer says it is off kilter in the last spin and when I try rearrange the clothing, it returns to 17 minutes and then does the same thing when it reaches 5 or 6 minutes to go.
- David Sutton asked 7 years ago
- last active 7 years ago
Whirlpool Fridge Model WRX735SDBM00, Ice maker not making ice…..what could be the problem? Fridge is only 2 years old
- Harley Clark asked 7 years ago
- last active 7 years ago
My microwave can not be used because of a code on the screen that says F9Q
- T&G Appliance Repair asked 7 years ago
- last active 7 years ago
My Microwave is in lock mode. How do I unlock it?
GE model number JNM7196SK1SS
manufactured December 2016
- David Sutton asked 7 years ago
- last active 7 years ago
MAH8700AWW Maytag washer. It does not spin, although I hear the motor running. No error codes. The timer in spin test does not wind down either.
- Harley Clark asked 7 years ago
- last active 7 years ago
Amana dishwasher doesn’t drain. It does wash. Water remains in bottom. Sounds like the pump is running when trying to drain. Model ADB1500ADS3
- Patrick's Appliance Service asked 7 years ago
- last active 7 years ago
My Bosch dishwasher has no electric power . Is there an overload switch I can turn on ?
- James Buchanan asked 7 years ago
- last active 7 years ago
