Repair Help

My dishwasher is showing an ER response on the digital readout…It will not allow me to cancel out the normal wash to return to no readout on the readout. It keeps telling me to add spot additive; I did this, but it keeps blinking. It makes a running sound and says washing/drying, but nothing is happening.

Vent will not raise or lower from time to time. You can hear gear/motor running but will not raise or lower when needed. Takes a while before it raise up or down. What should I check? or replace?

Kenmore 90 series
When the machine had completed two loads, a faint smell of “burning” came from the washer. There was no smoke under, on the sides, or behind the machine. Five
minutes into the next load, there was a stronger smell. I checked around the control panel and lifted the top door. There was no hot area or a overwhelming smell that identify
the exact location of the problem. When the machine was in 3-4 minutes of the first spin cycle, the washer shut off. I plugged it into the outlet after a day and a half, and it
worked again. Thank you for your help.

I get a lid lock error in diagnostics mode. However it stopped mid cycle. I did replace the lid lock, still no function. just beeping. I ordered the sensor control board but before I install it would like to know if it could be something else

Why Does My Gas Oven Glow Like It Is Hot Even When It Is Not Heating?

Will I Damage a Refrigerator or Freezer If I Store It in the Garage?

Why Do I Have Suds Left Over in My Washer?

What Makes My Oven Smell So Bad When It Is Cleaning Itself?

Frigidaire Dishwasher GLD2440REQ1 the display show CL even after starting a cycle. Then a minute or two later the display flashes 96 and CL very rapidly. This just started a couple of days ago.

Is there a replacement model for this GE microwave that will fit in the same place, hookups? model CVM2072SMSS. Touch pad not working at all.

If the condenser fan not running, can that make the evap freeze up?

Heater tested bad no continuity or resistance replaced but error won’t go away comes up after the cycle. How can I clear the error code?

This model has an in-line disconnect on top of the unit to supply the front door water dispenser. How does the disconnect on top of the unit get disconnected? I’ve got to take the doors off, but need to disconnect this supply line. Also, where do I find the release mechanism/latch for the bottom freezer drawer as it has to come out/off also. Thank you in advance.

P.S. Please forward any info requested to odbbly@yahoo.com – I’m presently at that address.

Again, thank you ! 🙂

Double oven will not work and keep getting F97. What is the likely problem? Lower cooling fan will not run. Found service bulletin that says to check connector. It’s a double oven so it will be very involved to take it down and really check it but as far as I can tell by peeking on it it looks ok. It says to replace cooling fan and sensor board if it’s ok. Is the cooling fan and sensor board more than likely bad based on you guy’s experience?
Thank you.

I have a bosch dishwasher showing an E24 code. What does this mean?

Hi our fridge has a water dispenser. It was working fine until 2 days ago. It is not dispensing water.

We have a french door refrigerator that has the freezer on the bottom. There is icy cold water that leaks onto the space underneath the long dairy drawer. We’ve replaced the water filter on time each time, but since the last 6-9 months we have been getting water pooling under that drawer.

Had a power surge during a storm and since then the microwave will not do anything.

The water line behind vegetable drawer in fridge is frozen, thus, no ice. How do i fix?

What motor should I purchase to replace it.

Keeps flashing error code 33.

Oven light turns on by itself , how can I prevent this from happening?

The ice container is broken and will not release to be removed from the fridge. Is there a way to remove it without breaking further?