Appliance Type: Refrigerator

Technician checked water valve good all door switches fine .Pushed the pad no voltage comes the water valve.
what could be the problem if you have the schematic will help also?

Temperature in FF section is to warm, customer sets it on 38 degrees and it is 56 degrees. What should I look for?

board, heater and defrost thermostat have been replaced. How do you check the defrost thermstat and the easiest way to replace it?

Fresh food side is not cooling well, it’s around 54 degrees. Freezer is ok. Put it to forced cooling and can see fan moving. Could it be board or sensor? How do I make sure? I need all the tips on how to find out or troubleshoot it. Thanks.

How do you enter into defrost mode

Why won’t the service mode work? Is there a “trick” to it? Could a thermister cause this? If so which one and where is it located.

Any ideas? I watched the videos on the service mode and seems I am doing it correct.

Freezer door won’t stay closed, gasket looks to be in good shape. When I got there I found the draw in the bottom of freezer compartment was sticking out in the way of the door. Fixed the draw where it was out of the way from the door from closing, but the door still wants to not seal tightly.

I have a GE Monogram I need to get the dispenser display removed to get inside to repair some broken pieces. However I am having no luck. Do you have any videos on how to remove the outer panel so I can remove the dispenser cover?

Need tech manual please. Refrigerator was turning on and off. Now completely dead.

Thank you

I’m trying to replace the main power board. replaced old board but the fridge dose not start up, no lights nothing, controls dead. I also replace the thermistor
Reinstalled old board fridge started up, lights working, controls working.
Installed another new board. nothing.
Fridge is also missing the tech sheet.
Initial problem, Items freezing items in fresh food section,
Thanks for your help

How do I test for not defrosting issue? Diagnostic is hard to follow. Also, is there a job aid for this model? I’m having a hard time removing the freezer bin and the slide rails.

Ice maker not making ice, I replaced ice maker, ice maker fan and ice maker defrost limit, I can’t get the fan to run. the ice maker will fill with water but will not freeze. it will cycle but will not freeze so it dumps water. the ice evaporator is working not frosted up. I think it will work if the fan would run.

Drain was plugged but evaporator was completely frozen over.I de-iced but not sure if it’s the board or thermistor or ?

Previously asked about this fridge before and you guys helped me locate a kit which helps with heating the drain pan and drain tubings —
https://www.appliancevideo.com/repair-help/question/dacor-built-in-fridge-leaking
I have been back 3-4 times now to unfreeze that drain tube. When costumer thaws whole fridge for a day every couple weeks the fridge starts to drain fine again for couple weeks and then issue returns. I installed kit exactly as instructions asked including disabling one of the temp defrost thermistors inside to make the defrost a standard 8 hours vs auto sensing defrost 8/12/16 defrost cycles. Issue still coming back, new heated drain pan over freezing and leaking out all over evap fan which gets disabled with ice.. its a pain in the rear job anything else i can try besides redoing the heated drain pan job?

THIS ICE CHUTE KEEPS FREEZING UP CAUSING THE UNIT NOT TO DISPENSE ICE.

I can’t figure out how to access the refrigerator evaporator, need a service manual.

Evaporator fans not running. Freezer fan will run intermittently. Both will run if test button is pressed once on the board. Is it a board problem or something else?

The refrigerator side is not keeping cool enough. The door just falls open and appears to have no suction. Normally on this unit the interior wall is warm but it is not warm on this one.

I have a Samsung refrigerator model RF266ABPN, it is not cooling (coolest it gets is around 50f), the freezer is working well.

I saw your video on how to fix it:
https://www.appliancevideo.com/samsung-rf266aepn-refrigerator-repair-not-cooling-properly-freezing-up-on-the-back-panel-evaporator-and-defrost-system/

In the video you have suggested part DA96-00516B Evaporator defrost system, when I clicked on the link to buy parts from the video it says part is discontinued and is out of stock.

What is the compatible part that I can buy to fix the problem – please let me know the part number and where to buy it.

Thanks.
Sudhin

Temp in freezer ok. Fridge stays at 28 degrees when set where it should be. Freezing food.

The water line part number AJR56656503 is cracked inside the back of the cabinet. It is part #616G on the diagram. I would like some help on how to replace it. thanks

I put this unit into forces defrost and the compressor shuts off but the heating element never turns on. Checked continuity on the heating element and the bi metal. Both are within spec. I replaced the jazz board and it still does the exact same thing. I’m not sure if I could have gotten another bad board that does the exact same thing or am I missing something. The unit does go into forced defrost and everything shuts down as it should.

There is a lot of ice building up in the Ice room section. This problem is occurring every few weeks or so that Ice will build up again and cause the Icemaker to stop working.

I bought one of your repair videos, but it did not include what the description said. I hope you can help me; my freezer is not producing ice.
I am trying to find the tech sheet for WRS965CIAM00. I replaced the emitter/receiver boards and lights did not come on (though it passes Test 15 in diagnostics). I’d like to run a diagnostic, harvest etc. (This is a link to a tech sheet on your page – but it’s to an oven tech sheet.) Thanks!

do you have a video on removing the ice maker