Appliance Type: Refrigerator

I replaced the water inlet valve and the dual inlet valves due to the failed continuity readings. I waited 48 hrs and still no ice. I also felt no water in the tray, so I thought the icemaker water line was clogged-replaced that, and waited 48 hrs, and still no ice. Before I did all this I carried out the diagnostic tests you showed, and all systems were normal. Water pressure is normal in back and the water dispenser pressure looks normal. Icemaker dispenser sounds normal. Any suggestions? 

My fridge is cooling but motor sounds like its running non-stop (not load but always running), I checked the back wall of freezer and saw that ice is building up.

The freezer section keeps thawing/sweating and has water in the bottom.

I changed the door gasket thinking it would fix it, but doesn’t seem to be sitting correctly.

Refrigerator section not cooling properly

I have a decent amount of water freezing in the bottom of my freezer and sometimes some water in the bottom of my refrigerator. What would be causing this? I checked temperatures and they seemed fine.

could u give some ideas what to check or do thanks craig

was able to replace it based on your video but it is still leaking and getting ice in the bottom. Do I have to defrost it? I did not do that or could it be something else wrong?

I have inherited a problem Amana BR18 Top/bottom refridgerator/freezer that is barely cooling the top but is freezing below, though with some defrost issues. I have been told that the prior tenant had attempted to fix some problem within the unit & that the fan motor was messed with in an attempt to repair the unit somehow? Can you help me possibly diagnose this problem? If so I will buy any new parts from you for the repair. Your help will be appreciated. Thank you.

Hi Guys, I’m going on a call tomorrow, “GE PSS27SGNA FRIDG SECTION NOT COOLING PROPERLY, Customer says the fridge is not cooling but the freezer “seems OK” maybe a little warmer…
Any known things about this model?

looking for a service manual or assistance if anyone has heard of this problem its is a french door with ice maker up in refrig section and we replaced the Ice maker and the fresh food thermistor problem customer is stating the ice cubes are soft and melting what might i be missing .

I just watched the video on how to fix the water on the refrigerator and it worked but now the blue part were the two tube come together its leaking now when I push on the water on the refrigerator help my husband told me to leave it alone but I found your video thanks but help

I am a servicer. I think this is an auger related issue. What steps should I take to trouble shoot to diagnose the related switches and circuits related to this problem?

Usually, when I OPEN the fridge door I can hear a fan motor stop. I don’t hear it anymore. Now, frost is building in the freezer and on the evaporator coils (not a lot.) Some water drops collecting on top panel of freezer.
Food items are still frozen, but the fridge is not as cold as it should be. Does the evaporator fan have two speeds? One for constant, low-level cooling and another speed for catch-up cooling?

My refrigerator General Electric GSH25JGCBWW is failing in two months to let cooling air seems like the fan is not working and 2 times nomas I have disconnected as 1 hour and begins to cool me know if will leave much repair

Google Translate for Business:Translator ToolkitWebsite TranslatorGlobal Market Finder

Turn off instant translationAbout Google TranslateMobileCommunityPrivacyHelpSend feedback

Unit has been making noise for the past couple weeks. Freezer is working,no obvious icing issues.Fresh food section is not cooling.Is there a sure fire fix?

My compressor is making noise, I like to look into it but need to remove the freeze bins (top and bottom) to get to it. I’m having trouble with the removing the bins. I was able to remove the door on the freezer, but I’m stuck on removing the bins. Seems like there are 2 tabs on the top bin that’s blocking the top bin from sliding all the way out. Is there a way to remove the blockers? Am I suppose to remove the top bin first then the bottom bin? Let me know if I’m going at it the right way.
Thanks,
-Frank

Ice maker is only crushing ice. The solenoid is not activating so the dispenser arm is not allowing cubes to dispense. I changed the solenoid, which was visually damaged on the inside, but it is still not activating. Would this be a Maytag Refrigerator Dispenser Actuator, part #W10205979, problem? The auger is working fine, it spins when the ice dispense pad is pushed.

My Amana frig & freezer (model#ACD2234HRB) were both warm, although fan would still run. After hearing a clicking & humming sound.The information I found noted that it was more than likely a bad relay/starter/overload then compressor. So I replaced the starter relay/overload/capacitor(?), part#W10613606 . After replacing it was making the same sound and clicking on and off, also still no cooling to the freezer or frig. But after pulling out the relay to check connections, I noticed the relay/overload was hot to the touch. I don’t have a volt meter to check the compressor or parts. Bad part?

I ordered a new part, just in case it was bad. The same thing, happens hums ,clicks on and off, repeats itself. Will not get compressor running. Relay/overload is hot to touch. Don’t have a volt meter to check compressor.

Model PFSS2MIYC SS
The door alarm was beeping intermittently as well as the display inside was going off and on. Now the display panel (inside) has gone blank but the refrigerator is still working. How do I determine whether to replace the main control board or just the one in the display? Thanks

Is there an issue with the temperatures or a part? Worried with the holiday coming, I need this working!

Still getting water to it, I checked the line, not sure what the problem is here.

Hi!
The problem is the following:
1. After turning on of a refrigerator, it works for ~2 hours, temp. goes down to -20 and +5 in freezer and cooling chamber, compressor stops
2. Then, after 10-15 minutes, it tries to start for 8-10 seconds, producing loud clicks and then stops. Freezer fan is working all the time.
3. Temp. goes up to +10 in both cameras, producing A1 or A2 alert.
If I give him a rest for 4-5 hours, this cycle repeats.
But some times (I don’t know why) this scheme breaks – compressor works (normally?), but temp. in cooling chamber rises up +10, meanwhile temp. in freezer drops to -26-27.
Thus, there is strange behavior – sometimes it seems to make vacuum in freezer, after the door is closed.

I turned off the refrigerator because I had ice build up on the bottom of the freezer. I tried to turn it on a few hours later and it would not start. It beeped and did not turn on. Now it doesn’t stop beeping and the display is turned off.

CHANGE HV BOARD, DISPLAY BOARD AND TOUCHPAD NO RESPONSE REFRIGERATOR HAS IN LIGHTS BUT DOESN’T WORKS

This started after a long overdue water filter change. I know that water comes through the filter on its way to the icemaker. When I hear ice drop and then the icemaker refill with new water, a puddle forms under the front left corner.