Repair Help

My LG washer is completely unresponsive.

My LG washer is making loud grinding noises.

What’s the best way to program board using logic door open. There is no toggle switch.
Value to Omar t number of coins it is coin drop not slide
Uses Control board WPW10130081

I am having difficulty programming this washer to set up coin drop coins and also to have the display show how many coins are required. This is not a slide coin.

GOOD MORNING. THE CUSTOMER PURCHASED A NEW ICE MAKER. I DO HAVE 110 VOLTS AT THE MOLEX TO THE ICE MAKER. I INSTALLED THE NEW ICE MAKER AND JUMPED FROM L TO V AND T TO H WITH NO RESPONSE. I TESTED BETWEEN ALL TEST PORTS AND COULD NOT GET ANY VOLTAGE READING. I THEN INSTALLED THE OLD ICE MAKER AND JUMPED THE L TO V AND T TO H WITH NO RESPONSE. THEN I TESTED ACROSS THE L AND N AND GOT 110 VOLTS. PULLED THE MOLEX FROM THE ICE WATER INLET VALVE AND GOT 75 VOLTS WHEN JUMPED FROM L TO V. THESE TESTS WERE PERFORMED WITH THE FLAP AND DOOR SWITCH MADE. WHEN FREEZER DOOR IS OPEN LIGHT IS BLINK BLINK PAUSE. WHEN I CLOSED THE FLAP IT REMAINED BLINK BLINK PAUSE. NEVER BLOCKED OPTIC EYE WITH MY HAND. ANY HELP WOULD BE GREAT. THANKS, TODD FROM NY.

My washer wont spin out

My LG washer is very loud

The steam function on my LG washer is not working

My LG washer is slowly leaking water.

Do you have any suggestions or service manuals to rectify this issue?

My LG washer is making loud high pitched noises.

My washer is unresponsive

Do you have a service manual?

I cannot get any pads to work to enter code

The interior light flashes as well, when I close the door I can reset my temperature to my desire setting until the doors open again then it resets once again. You may contact me at 606-349-6700 or 606-349-6717.

Thank you for your time and have a nice day

why the refrigerator doesn’t cooling in both side. freezer and fresh food side.

Moisture is building below the fridge I have seen this on several of the side-by-side Vikings the drain pan would be on the right side and there is a gutter that runs from the left side which is the freezer drain hole to the right side and it’s always really wet around the beginning of the gutter which is the bottom of the freezer side, it would be covered In really big droplets hanging down. The little axle fan located in the front right came on after resetting the fridge which I am assuming is to dry out the bottom of the unit. Do you guys have any ideas what could be causing this or what I can do? I put a cookie sheet there temporarily. Diagnostic mode didn’t tell me jack.
This unit does not have a drain pan heater but the drain pan is wet inside so I know water is getting in there and there is no water damage below the drain pan only wear those droplets are hanging from

only the heavy wash and high temp dry buttons work or will light up and when you push the start cancel button nothing happens. When you close the door the display lights up but the wash light does not come on and nothing happens. after a minute or two the display shuts off. Ocassionaly it will work bit only on heavy wash and high temp dry.
I replaced the control panel and the same thing happens. Your video showed the same symptoms and was resolved by changing the control panel. I am hoping I do not have to change the control board as that is another $100 + part.

Can you tell me entry code for diagnostics. Some wonderful person took it. So now I cannot get into it. I tried the one I could remember but memory is not good. Only goes to figure. Help

I have 13e and 26e I cannot find what they mean

GOOD MORNING. I WAS TOLD THAT THE WASHER SHOWED A 44 THEN A SUD CODE. WHEN I GOT THERE THE WASHER DOOR WAS LOCKED AND WATER WAS IN THE DRUM. I REMOVED THE DRAIN PUMP AND THE IMPELLER WAS CLEAR AND MOVABLE. I SHUT THE WATER TO THE WASHER AND STARTED A CYCLE WITH THE PUMP DISCONNECTED. THE PUMP WORKS, BUT MAKES A LOT OF NOISE. I PUT IT BACK TOGETHER AND IT WILL ENGAGE, BUT NOT PUMP WATER. THE WEIRD THING IS THAT WHEN I REMOVED THE PUMP FROM THE HOSES AND KEPT IT PLUGGED IN IT WOULD CONSTANTLY RUN EVEN IF I HIT THE OFF BUTTON. WHEN I DISCONNECTED THE ELECTRIC AND RECONNECTED THE ELECTRIC IT WOULD CYCLE ON AND OFF NORMALLY., BUT NOT PUMP WATER. ALSO ALL HOSES ARE CLEAR. ANY HELP WOULD BE GREAT. THANKS, TODD FROM NY.

I found the primary interlock switch faulty on arrival, replaced and still had the same issue. The fan that comes on when the magnetron is active is only turning on when you open the door. I confirmed all the micro switches were functional at this point. My experience in the past is that one of the switches would cause this. I am suspectin that I am missing something here.

(Viking fridge brand. search has issues finding after error due to not selecting appliance type)
Replaced gasket and fresh food door doesn’t stay closed. NO THIS MODELS HINGE IS NOT UNDER RECALL. Tried raising the front of the fridge and nothing. Rubbed a bit of lube on gaskets, nothing. Tried udjusting the top hinge bracket in different directions and nothing. Put old gasket back on and seems to be staying closed at least a lot better than new gasket. I was thinking to heat gun the gasket until it compresses better like the old one? But why does the freezer close so well and these Viking side by sides always have issues? What are some other things I can try besides heat gun the new gasket a bit so it isn’t so thick ??

The fresh food damper stays open, I can’t locate where thermistor is located. Can’t find any videos on this model

do you have a video on how to remove freezer door and the icemaker? there are two pull out freezer doors, icemaker in one. need to remove icemaker.

need info

need info