Repair Help

The unit is a side by side, inside of the freezer door is a snow like light ice build-up on the front of the ice bucket. if you leave the door shut for about 3 days the build-up will continue down the ice chute.

when you put test value on line do you have to remove it are can you leave it on ?

Ran through diagnostic mode it flashed the lights indicating it was the main board malfunctioning. Replaced main board. Still won’t complete the cycle. Could it be the board below the drum? Ran fine when I left the appointment. But sometimes it took longer then usual to drain. When I ran through diagnostic mode. Tested it 4 times before I left.

The door is not locked however I’m still getting this message.
It happened once before we unplugged it and it worked fine now however we unplug it we get the power failure message and then F5 E7

GE front load washing machine. When you turn the machine on and hit start, it does not do anything mechanically (will not fill with water, spin, etc) but it shows the cycle counting down on the display. Pump made a noise one time but that is it. We suspect a control board but are not confident.

No ice in bucket

Fridge wasn’t cooling changed damper control worked for one week then call back stating still not cooling
Tested everything . Fine No leaks nothing .
All parts working other then have no way of knowing if control board is faulty .

Need falt codes manual all codes

WM3180CW NEED MANUAL

I need a service manual on the LG SIGNATURE SideKick Pedestal Washer

Hello I have been working on a lg washer with nothing lighting up on the control panel. I have 120V to the control panel. So naturally I assumed it was a faulty panel. Replaced it with a new one. Still nothing lighting up. I began to jiggle the control harness that connects the main board and control panel. The display came on I moved it again display went off. I ordered the wire harness replaced it and still no lights. If you have any ideas I would greatly appreciate it.

What is the temperature rating for part #WP67006387 defrost thermostat?

I have a washer that will not turn. it jerks a little but never does a full turn. I changed the lower board and the stator any thoughts?

I checked the leads coming from the compressor I am not getting power to it please advise

Samsung French door unit. Pressed power freeze and lighting buttons. Freezer display toggling back and forth 88/89 ff display at 88

We purchased a dispenser module for our Electrolux refrigerator. It mounts behind the interface module. We cannot, for the life of us figure out how to remove this part. PLEASE HELP!

Grinding noise during spin cycle. Does the gearbox need replaced or is there a tub bearing in this model? It makes the noise when I spin the tub by hand. Thanks Ricky

I need part number for the tool

I have a pump that runs all the the time it washes it just will not spin

Customer complaint is the cubes are small, and only a handful of small cubes unit runs fan runs.
Have not checked the unit yet, do you have a service manual on this Scotsman stand alone ice maker unit.
Any advise and service information would be helpful as I have not checked the unit yet. Thank you in advance for your help.

It seem like the circulating motor is not working a nd the tech sheet is missing, so I can’t check the circuit board.

I am assuming the filling of the tray for clothes softener at 15 minutes remaining is causing the problem.
Why would it leak?

Hello, Technicians, thank you for your help. I am working on a whirlpool cabrio washing machine, the detergent dispenser hose is leaking in the floor on the back of the washing machine, according to looking up the parts I have found I have to replace the dispenser with the hose, my question is do you have a service manual or a video that would assist me in removing and reinstalling the detergent dispenser?. just want to be sure I do it right and don’t damage something. Thank you for you help. I look forward to your advise and your help.

Could you supply me with info on this model