Repair Help

I have replace door lock and door switch the washer door still buzzes when I close it doesn’t lock and start what could be the next problem these parts are brand-new do you think I could have a defective part or is there something else I need to check.

Hello

I had a repair guy come to my house that i had a bad heater circuit. what is that is it in the main board?

It runs no glow I do not hear the solenoids fire can you help?

THERE ARE NO LIGHTS OR DIGITAL DISPLAY IN THE REFRIGERATOR COMPARTMENT. I THOUGHT IT WAS THE DOOR SWITCH BUT THAT IS GOOD. HOWEVER, I’M ONLY GETTING 50V AT THE SWITCH AND IT FLUXUATES. I HAVE SEVERAL OTHER TEMP CONTROL ASSEMBLIES AND THEY ALL HAVE THE SAME ISSUE. THESE CAME OUT OF OTHER UNITS SO I SUPPOSE THEY COULD HAVE THE SAME ISSUE. THE ORIGINAL ASSEMBLY WOULDN’T KICK THE COMPRESSOR OR FANS ON AT ALL. I’M NOT SURE OF THE CURRENT PATH OR IF THE POWER IS ROUTED THROUGH ONE OF THE BOARDS IN THE CONTROL UNIT. ANY THOUGHTS WOULD BE APPRECIATED. THANKS

I’M GETTING THE SAME VOLTAGE TO GROUND AS THE NEUTRAL.

I CORRECTED THE MODEL NUMBER THE S WAS A 5.

DOOR SWITCH IS GOOD. DO YOU HAVE ANY SERVICE INFORMATION ON THIS DISHWASHER IT POWERS UP WONT START. DO YOU HAVE A SCHEMATIC ON THIS MODEL. OR COULD YOU TELL ME HOW TO PUT IT IN THE SERVICE MODE TO SEE ANY FAULT CODES. THANK YOU FOR YOUR HELP.

GOOD EVENING. I AM TOLD THAT THE DRYER IS TAKING TOO LONG TO DRY. SOME TIMES IT WILL WORK BETTER ON DIFFERENT CYCLES, BUT THE TEMPERATURE SEEMS ON THE LOW END. ANY HELP WOULD BE GREAT. THANKS, TODD FROM NY.

I need to replace the fresh food evaporator fan motor and I’m having trouble removing the access panel to the motor.
Thanks for any help you can give me!
Charley

The unit is making a loud humming noise like a fan. The lower freezer unit is not freezing. It is cold . The upper unit seems to be working. I put a thermometer in and the top part is staying at 33 degrees. No error codes on the unit.

do you have a break down of this machine. makes a loud noise when it spins. at the bottom of the shaft their is a plastic piece which the spline of the shaft runs into the shaft seems to be slipping in the plastic. can you give me an idea what to do to repair this problem. thank you.

Customer complaint is the washer has increased spin speed in the last week or two
Spinning too fast

do you have the wiring diagram for this unit?

have checked 240 coming into the dryer, have power to the main control board. is there anything else I should check. could a door switch cause it to not power up at all. the drum light does not light all displays are dead

We change filter and after start display er ff code and stop making ice

Replaced left corner evap fan in bottom portion of French door Kenmore elite (LG design) fridge then costumer said icemaker hasn’t worked since which is located in the fresh food section. He unplugged fridge didn’t solve it. Do LG design icemaker reset like Samsung ones? And is my work related to this is the ice maker is in the fresh food section where I haven’t been?

GOOD MORNING. I AM TOLD THE DRYER RUNS FOR ABOUT 15 MINUTES THEN MAKES A LOUD BUZZING SOUND THEN STOPS THE CYCLE. THE DRYER DOES HEAT DURING THAT TIME. ANY HELP WOULD BE GREAT. ALSO, THE DRYER WASHER STACK IS LOCATED IN A CLOSET IN FRONT OF NEW TILE, IS THIS REPAIR DOABLE WITH OUT MOVING THE UNIT? THANKS, TODD FROM NY.

Left rear burner on this gas cook top will not spark. I have changed the switch harness and the spark module. You can take a screwdriver and lay on top of the ignitor and it will spark. I have checked the wires and don’t see any bare spots and also the ignitor is new. Any suggestions or ideas?

filling and draining at same time. leaking on floor