0 votes
2k views

Hi, Cannot get this machine to enter the diagnostic mode. Took out the board and it looked good, not obvious marks. Any ideas?
Thank you,
Barney’s Appliance

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
3k views

the broil works fine .
but the bake will not glow or heat.
the ignitor is good.
on the panel it says 100f
and stays at that.
also if I put on convention the fan will not start.
I don’t know if it needs to heat up first.
but only the bake ignitor is not working

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
3k views

Tried to put into diagnostic mode, would not except. Unpluged the unit and tried within 6 sec’s still won’t. When you hold the start button for 3 sec’s it llocks the door and under the unit the actuator moves back and forth then tries to run the mot.or. The motor stops then actuator moves back and forth again and doen’t do anything. Not getting it to go in diagnostic mode you can’t tell whats going on. any thing you might know about this machine would be helpful.
I checked the computer board all plugs are seated and all tight. The drain pump works and drains the water out.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

the unit will go on a 44 minute cycle.
and it’s at 43 for over ten minutes.
I cleaned out the drain line.
I hear some noise from the motor but it will not turn .( I can turn it by hand ).
and every few minutes I hear the water go in for about 1 second.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

I am having a problem with a Fisher & Paykel Washer.

0 votes
3k views

I am having a problem with my Kenmore refrigerator. It is not cooling properly in the fresh food section.

0 votes
2k views

My Samsung dryer is not getting any heat.

0 votes
2k views

I am having an issue with a Bosch dishwasher.

0 votes
2k views

Having an issue with my Samsung refrigerator.

-1 votes
2k views

everything is flashing turn the brake off and on and I get the same flashing lights.
can not get the unit to work

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
4k views

Fridge section cooling fine but freezer drawer not cooling at all. What should I be looking for.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

the freezer is not really cold
I checked the freon in the compressor it was -10.
I tried to fill it but I’m still getting the same reading.
I put a leak sealant and when I put the gauge on it goes to 60psi put then drops back down to -10.
please advise

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
3k views

Can you tell me what could be causing this issue on a GE Dryer? It is having these problems: Dryer will not heat up

0 votes
2k views

My LG washer is not working properly.

0 votes
3k views

My Samsung stove has no power at all.

0 votes
3k views

My Samsung stove is not working properly.

0 votes
3k views

My washer is not working properly.

0 votes
3k views

My microwave does not heat properly.

0 votes
3k views

Hello I have a question on a Electrolux Refrigerator. I’m noticing these issues: Water dripping from dispenser

0 votes
3k views

My Fisher & Paykel dryer is not heating.

0 votes
3k views

Hello I have a question on a Maytag Washer. I’m noticing these issues: Wash Basket vibrates

0 votes
2k views

My Kenmore refrigerator is running very loud.

0 votes
3k views

My customer’s Bosch Dishwasher is having some issues. Will not stop running

0 votes
3k views

Hi how do we replace switch membrane for this model

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
3k views

This unit turns on and replaced the Compressor sensor and still not cooling.

  • Guest asked 9 years ago
  • last active 9 years ago
0 votes
2k views

My LG washer will not start the cycle.

0 votes
3k views

My Maytag washer is not working properly.

0 votes
3k views

My LG dryer is displaying a DE error code.

0 votes
2k views

My Samsung stove is making a weird noise.

Showing 5941 - 5970 of 9k results