Appliance Type: Refrigerator

On my refrigerator the freezer is cold but the refrigerator is not cooling. Started about a week ago when the freezer was freezing over And the refrigerator and we heard a loud noise like. We were told we needed to unplug the fridge for a few days because the fan was hitting blocks of ice. So we did and now the noise is going but the fridge section will not cool down the freezer section is very cold. Do you have any idea what this could be?

• Samsung Refrigerator mode # RF28R7351SR/AA
  ICE shute opens and closes on its own. The display works fine and you can change between water, crush or cubes. The shute opens and closes repeatedly non stop. Dont know where to begin troubleshooting.
  Thank you

I have a Family Hub Refrigerator with 4 doors. The freezer section (bottom left) no longer freezes. The flex zone (bottom right) now seems to not be cooling as well as it use to (used as a fridge). Fault history shows error 83: Compressor Current & 84: Compressor Motor from about 6 weeks ago. However, those faults do not show anymore when running a self-diagnosis. I receive no errors during a self-diagnosis. I’m. trying to figure out if I should try replacing the PCB inverter board, or if it’s a more serious issue.

I did replace the compressor and evaporator and heat exchanger on the sub zero model 680/s
Everything is running but not compressor,
Please I need advice and seal system service manual .

I’m following your video for replacing an axial fan motor: https://www.youtube.com/watch?v=-67goBr-cFw However my fan motor is connected to the bracket not by metal screws as shown in the video, but by four silicone connectors. I don’t know how to disassemble these silicone connectors and then reattach them once the new fan motor is on the bracket. Please email me or call/text 8326462529. Freezer is powered down so immediate response requested. Thanks

I have a whirlpool side by side fridge that is making ice but will not dispense water thru the door. When I push the dispenser arm it sound like it is trying but no water comes thru.

CUSTOMER CALLED US ORIGINALLY BECAUSE THE FRIDGE WASNT COOLING. WE REPLACED THE MAIN CONTROL BOARD ON THIS UNIT AND IT BEGAN TO COOL WITH NO ISSUE. NOW THE REFRIGERATOR IS NOT MAKING ICE. WE HAVE REPALCED THE ICEMAKER BUT IT WONT CYCLE OR MAKE ICE. WE PUT IT INTO DIAGNOSTIC MODE AND UNDER THE ICE MAKER DIAGNOSTIC THEN IT CAME UP WITH ERROR CODE “23”. WE NEED TO SEE WHAT THIS MEANS AND WAHT THE REPAIR IS FOR THE CODE.

We replaced the icemaker on that unit water valve is working good but I’m trying to test the ice maker. but the icemaker not working at all I’m trying to jump the H with T to test the ice maker but not working.
Any video, any advice that can help me please,

I have Trouleshooted this unit, By; Running a Diagnosis-TEST on the Control board!!! 1.,2.,3., & 4. push on the test button, ALL the TESTS check out!!! There is NO-Check light flashing at ALL!!! BUT, this is the NEW type of Commpressor on this LG unit {Linear / Inverter Compressor}… I DO-NOT Know what Voltage should be going to this unit!!! The Compressor’s; sticker said: INVERTER 0–220V 53Hz… SO, when I check it with a DVM, I get a reading of; 35 Volts!!! The Compressor is Running, With “ALL” the Fans too!!! BUT, NOT–COOLING??????????????

What do you Think?????????

I have a miele refrigerator freezer on the bottom fridge in the top. the icemaker leaking water I check the icemaker tray is good everything is good but water not completely coming to the icemaker from the unit.
Water valve also good. I wanna diagnostic the icemaker I need service manual how to put it in diagnostic mode the icemaker.

The refrigerator section is getting too cold and freezing things. The Desupply damper by the pan doesnt appear to be opening could this or the chill fan be the cause of this issue.

The freezer fan motor only runs when the door is open

Replaced inverter board and still not starting
Inverter board blinks Green two times.
Has 120 volts going into inverter board but only 78 volts to start compressor to the pins.

The icemaker tray won’t dump if I push the test button it will dump sometimes but most times it won’t. The tray has a regular amount of water in it there is no spillage it seems to be a mechanical issue? Is it as simple as replacing the ice making unit in the door?

I have a situation with frost forming on the ice bucket, already replaced the flapper, it seems to be closing fine, no leaks around door gasket. Seems to reoccur about every 2 weeks.

Right door is not closing all the way and keeps popping out. Any videos to fix this issue. Tried hinges, gasket and stoppers nothing working.

the refrigerator side stays at the set temperature, but the freezer side doesn’t go lower then 41 degrees I have the setting at 5 degrees.

See above. Newer model Samsung French Door refrigerator. Display is on the right hand side on interior of refrigerator. Above “Fridge” button flashes the letter C. Above the “Freezer” button flashes 40, 24, 25, and 65. Unit appears to be maintaining temp however it will intermittently trip the breaker. We have replaced main control board already.

I am trying to replace the touchscreen control board on my refrigerator. I need to know how to remove the display panel to get to the board. Looking for help or a video to show me how to remove the touchpad to get to the control board. This is a Samsung French door four-door refrigerator not a side-by-side.

Looking for a list of diagnostic codes for my GE fridge.
Not sure my freezer heater works and want to run a test. And also test the thermistors.
So need tech sheet or service manual for my specific fridge.

Attempted to rewrite control board after compressor replacement only getting failure from jig after attempting rewrite

I wanted try to fix Ge fridge video on repair for beginners

This unit has a failed compressor and it states we have to update the board on this unit. Do you have any instructional materials, or guides on how to complete this common LG compressor repair. Kenmore Refrigerator – LG BUILT

I have this frig I’m really lost on ran the diagnostics says there a short in the defrost system.But the weird thing is both evaporators are frozen up frig and freezer.Would this be a control board problem.please help I’m in the hole on this one thanks Jim

Bottom icemaker not working. Fridge runs great and upper icemaker in door works great. Have replaced main control board (unrelated to icemaker), 2 different icemakers, and a water valve. Icemaker won’t even turn fingers to flip out ice. I put a bit of water in the icemaker to see if it was valve or icemaker and still no ice flipped out.

Need to resolve ASAP because fridge is taking up space at store and can’t be sold until icemaker issue is sorted.

Need to know how to dissemble icemaker compartment to install evaporator Kit 5303918444.

No matter where the control is set it freezes every thing.
How do I test this unit?
I need a service manual and tech sheet and any advice you can give