Repair Help

Model # DLE2516W
Dryer turns on but doesn’t turn all sensors seem to test ok except for The one with the red wires I’m not sure how to test out one what could be my problem

Model # ATF6700FS1
When I press the power button the machine powers on the door locks then unlocks The lights indicate fast spin then goes to no spin then the machine powers off what could be my problem

Door latch buzzes 3 times and won’t unlock
No error code comes up

This is a dual wall oven
The problem is the doors are not closing all of the way.

Is there a way to adjust the cam? The spring does not have enough tension to fully close the door.

It’s clear how it works. It’s also clear how to remove it. What I do t get is why it does not work. It’s almost like to four springs (one for each hinge) is now too long to close the door correctly.

I’m hoping you will come back and say “Do this to adjust the spring tension”.

Look bellow for links to two photos of the hinges:

View post on imgur.com

I have two of the same models 1st one no water on any cycle. I have 110 volts on temp controller.also sometimes it goes through cycles when water was working. 2nd washer starts agitating when water comes in. but the water level is to low in tub

Working on one that gets a F11/F12 fault every now and then.

I have an apartment building full of these machines. Today I had a machine that the door is locked and will not release. Machine works fine except for the fact that you can’t put any clothes in! It will not release, per manual, in the time or anytime powering unit down to let the latch cool. Does anyone have a way to open the door to replace the latch ?

Hello
Older side by side GE refrigerator – complaint is that ice clogs the chute – when calling for ice it seems as if the ice comes out of auger bucket too soon and doesn’t allow the door to open in time – I replaced the time module delay (WR55X129) in the hopes that that was the culprit – almost a month later and the customer is calling back with the same complaint. Ice size seems appropriate and dispenser door seems to open and closer properly. Ice cubes are proper thickness and good water supply to ice maker . Thanks for any help

Have a Frigidaire refrigerator that when ice is being dispensed it doesn’t stop when paddle is released.
Doesn’t stop when water is being dispensed when paddle is released…

Any suggestions?

THE UNIT WON’T COOL AND HAD VERY LOW PRESSURE ON THE SUCTION SIDE. I REMOVED THE FILTER/DRYER AND CLEARED THE CAP TUBE WITH NITROGEN. I HAD GOOD FLOW COMING FROM THE CAP TUBE AS WELL AS THE LINE ON THE OTHER END OF THE FILTER DRYER. I RECHARGED WEIGHING IN THE 134A TO SPEC. MY PRESSURE -25inHg vac AND 60psi. IT DOESN’T APPEAR, TO ME, THAT I HAVE A BLOCKAGE. I’M SUSPECTING COMPRESSOR SEALS. DO YOU AGREE OR WOULD YOU RECOMMEND ANOTHER ALTERNATIVE ACTION? ANY ADVICE WOULD BE WELCOME. THANKS

looking for which pins to check on board to see if ice maker is receiving voltage and signial from board

THE UNIT HAS UNUSUALLY LOW PRESSURE ON THE SUCTION SIDE. I NEED TO FIGURE OUT HOW TO GET THE 3-WAY VALVE IN THE MIDWAY POSITION TO VACUUM AND RECHARGE THE SEALED SYSTEM.

GOOD EVENING. I SPOKE TO THE CUSTOMER AND WAS TOLD THAT THIS STARTED ABOUT SIX MONTHS AGO, BUT THEN WENT AWAY. IT STARTED AGAIN THE LAST COUPLE OF DAYS. ANY HELP WOULD BE GREAT, THANKS. TODD FROM NY.

Ice fan not sure if it is working? Send me a diagnotic sheet on this refrigerator so I can test functions on the computer board.

I set the oven to 350 and it starts off at188 and within 3 seconds it’s at 350 and the oven is cold.
and the fan ( not the convention. the one on top ) will just run and run.
it happens on any cylce

Water from the disposal was backing up in to the unit. It didn’t have a drain loop. The DW started draining continually and will only stop If I turn the breaker off. It will not cancel or clear. Is there a trick to clear it so it will run again? Ican’t program any cycle. I added the drain loop and all the water is gone, but still won’t quit draining

Do you have any video on how to change a cooling fan on a Frigidaire oven, part # 318575600 ?

We sell parts over the counter to retail custumers, we are looking for repair videos to help them. Do you have a list of your free content ?

I have a no cool refrigerator with the linear compressor can you give service information. I need any information you have on this unit. Never worked on one before.

My Maytag top load washer is leaking. Seems to be occurring during drain cycle. I removed back cover and attached to drain hose is a smaller clear rubber hose, 8572540 FSP. The clear hose has a deep groove worn into it, assuming caused by vibration from rod it is attached to. Looks like this is where water is coming from. Is that possible? If this is the problem, what is name and part # for this hose, or can I use any clear tubing of the same size.