Repair Help

My Whirlpool dryer is displaying a 01 error code.

My amana dryer is making a loud squeaking noise.

My Whirlpool dryer will not start and only makes a clicking noise.

My Whirlpool dry only heats sometimes.

My Frigidaire dryer is not drying clothes properly.

My Kenmore Dryer is not heating

My Maytag dryer is not heating

My Whirlpool range is not heating.

My Whirlpool dryer is making loud horrible noises

My GE oven is not heating.

The freezer in my whirlpool refrigerator is icing up

My Kenmore dryer is not heating

My Maytag washer is leaking water

The ice maker is dead, the reset button does nothing. Will the im harvest if the ice room thermister is bad? Does the wr23x10580 interchange with the wr55x10025? Do they share the same resistance ratings at certain tempuratures? Is there anything I didn’t check?

Its fills with water and drain it right away

The lid on my Whirlpool washer will not lock.

My Hotpoint refrigerator is not getting cold enough.

My Jennair microwave will not turn on.

I CHECKED OUT THE REFRIGERATOR AND THE EVAPORATOR FAN HAS POWER, BUT IS NOT WORKING. I NOTICED THAT THERE IS A LARGE BLOCK OF ICE ABOVE THE RIGHT SIDE OF THE COIL, NOT ON THE COIL. THE COIL DID HAVE SOME UNEVEN FROSTING. THIS REFRIGERATOR IS KEPT OUTSIDE AND THE NIGHT BEFORE I CHECKED IT THE TEMP OUTSIDE DROPPED DOWN. THE BLOCK OF ICE IS NOT BLOCKING THE AIR DUCT, SO IF I REPLACE THE FAN IT SHOULD FIX THE FRIDGE TEMP PROBLEM, BUT I AM CONCERNED WITH THE ICE BLOCK AND UNEVEN PATTERN ON THE COIL. I WOULD LOVE TO PUT IT IN MANUAL DEFROST, BUT I DID NOT KNOW HOW. I TOLD THE CUSTOMER TO EMTY THE FREZZER AND LET IT DEFROST. WHEN I GO BACK WHAT SHOULD I CHECK? THANKS, TODD FROM NY.

Hi Folks,
This dryer was in a very poor condition. The pulley had fallen off the fan and the owner kept using it with no circulation of heat. No fuses were found to be defective. Element checks out! Proceeded to clean the unit thoroughly. Took care of the pulley and circulation problems. Put it all back together and no heat. Check the board and it was fried. Installed a new board and still no heat. There was no tech sheet with the unit! Now I have 240v going to the board (two legs of 120v each) but where do I find the legs coming out. It’s the heating cycle because the dryer is turning but no heat. I need a tech sheet and some expertise on getting this unit on board!
Thank you,

Jan
Barney’s Appliance

Piece of ice forming in rear bottom right of refrigerator section, melting and leaking out the front of frig.
Is this like the french door with two evap coils? am I looking at a frozen drain?
Temps are ok.
Thanks for any ideas.

Can you give me some help, I would appreciate it.
First let me tell you, my dryer is completely apart! When the dryer was put on “Time Dry” it did not dry the clothes. It at first got slightly warm. And then went thru the whole time without drying the clothes.
What would you consider the most likely part(s) to be ? And how would I go about testing the component(s) with VOM?
Thanks for your help and time, Rich.

My Frigidaire washer keeps pausing mid cycle

My Whirlpool washer is not draining.

My Frigidaire dryer will not start.

My Frigidaire washer is not draining properly.

My Frigidaire washer is displaying an “e21” error code and is not spinning out

My RCA refrigerator is not cooling properly and compressor is not running