Repair Help

Lady replaced water filter and the replace filter comes on. Is there a filter reset on this model. And the lady has no idea where the use and care book is. Thanks.

Some water is left in front loader tub when washing towels.
Gives ND code.

Dishwasher does not start after selection.
Drain cancel always comes on and drains even after entering diagnostic mode.

I need to remove the door and baskets to get to back. do you have a video? this is a bottom freezer with French doors.

DDT575SSF0SS Model will not start after I replaced door latch and got GE tech line went through the service mode it went fine. But unit will still not start, control works.

Installed a new board and have been getting beeping sounds I need to do a reset do I not..?

I am replacing the fresh food evaporator fan. I have watched your video on a similar model. This one is a 5 door and I’m not sure how to dismantle the draws and the center adapter between the two drawers.

I have no cool in freezer but refrigerator is fine. Any suggestions and also no error codes came up

Water is in the freezer floor. I think it might be a defrost drain isssue. Have not checked it yet. But would like the service literature if possible. Thank you. For your help.

Smart Auto and Heavy LED blinks at the same time when it goes to drain cycle.
The manual said “Functional Error. Turn off the dishwasher and try to start it again. If the problem continues, contact the authoizedSamsung service center.” Do you know how to fix this issue? Thank you.

Can we get more advanced videos for example how to remove the bottom hinges off a Viking side-by-side refrigerator not specific to a model? Or how to replace hinges on a Viking or Thermidor or wolf range? Please more Advanced videos or links to some regarding more high end appliances this site only includes some minor repairs.

I replaced the thermal fuse a week ago and the customer tells me that it blew again. What is causing this to happen?
1. I replaced the dryer vent hose the last time that I was there.
2. I cleaned the inside of the dryer as well.
3. I checked the flappers outside and it is working.

Dispenser Problem/ Repost from yesterday
Refrigerator Frigidaire
Unexpectantly the dispenser hatch rapidly opens and closes and if the dispenser is set to water it comes out each time the dispenser opens and closes. What is the cause of this problem? The customer said she googled it and found it is a common compalint. Is this so?

The main problem is NOT trickling water but that whenever the dispenser WANT’S TO; ALL ON IT’S OWN ACCORD it , at any time opens and closes its hatch over and over for several second’s then stops. Without ryme or reason. Wouldn’t this be a circuit board issue? and call for replacing it?

I replaced the dispenser module first and that didn’t help at all. Then I reinstalled the old one and replaced the main control board, and that seemed to fix it then after three trouble free days then it started again. Now what do I do? Is the display a possible cause? It is almost $500.00. Any other ways to try to determine what is the problem?

This dispenser module you sent is the one I replaced. 242100019 Sorry for the confustion. Any other suggestions

Did you and the factory technicians determine what is causing this?

The ice maker on top in the refrigerator does not work. I replaced ice maker with new one and still not working. The ice maker is controlled by user touchpad on the outside of door. It is turned on but still no ice. Do you know how to get into diagnosis mode so that I can test the ice maker? thanks Ricky

This is a Kenmore Coldspot. The ice maker was replaced 4 months ago. Now the water is freezing up in he chute going to the ice maker.

The customer insists the glass isn’t big enough to be held by to clips on the inside of the door. replacing the outer glass calls for 316452702. anyone know of any issue with this

Dispenser Problem/ Repost from yesterday
Refrigerator Frigidaire
Unexpectantly the dispenser hatch rapidly opens and closes and if the dispenser is set to water it comes out each time the dispenser opens and closes. What is the cause of this problem? The customer said she googled it and found it is a common compalint. Is this so?

The main problem is NOT trickling water but that whenever the dispenser WANT’S TO; ALL ON IT’S OWN ACCORD it , at any time opens and closes its hatch over and over for several second’s then stops. Without ryme or reason. Wouldn’t this be a circuit board issue? and call for replacing it?

I replaced the dispenser module first and that didn’t help at all. Then I reinstalled the old one and replaced the main control board, and that seemed to fix it then after three trouble free days then it started again. Now what do I do? Is the display a possible cause? It is almost $500.00. Any other ways to try to determine what is the problem?

This dispenser module you sent is the one I replaced. 242100019 Sorry for the confustion. Any other suggestions

Does this question goes against my quota?

Dispenser Problem/ Repost from yesterday
Refrigerator Frigidaire
Unexpectantly the dispenser hatch rapidly opens and closes and if the dispenser is set to water it comes out each time the dispenser opens and closes. What is the cause of this problem? The customer said she googled it and found it is a common compalint. Is this so?

The main problem is NOT trickling water but that whenever the dispenser WANT’S TO; ALL ON IT’S OWN ACCORD it , at any time opens and closes its hatch over and over for several second’s then stops. Without ryme or reason. Wouldn’t this be a circuit board issue? and call for replacing it?

I replaced the dispenser module first and that didn’t help at all. Then I reinstalled the old one and replaced the main control board, and that seemed to fix it then after three trouble free days then it started again. Now what do I do? Is the display a possible cause? It is almost $500.00. Any other ways to try to determine what is the problem?

This dispenser module you sent is the one I replaced. Sorry for the confustion. Any other suggestions

Drains in drain and spin, but will not drain in the regular cycle. We have already changed the actuator.

needed new control board which i changed but now dryer keeps beeping does it have to be rested some how.

I need the wiring esquematic

freezer ok frsh food side not cooling

What are some of the things I should be looking that could cause a 7e error code

ADC ADAPTIVE DEFROST BOARD PCB traces bad near orange and red wires for compressor one trace no continuity to relay on PCB board.

Gunk in the bottom of dishwasher draining lots of soap after failed washes
Pump doesn’t seem to pump water as fast as it should

ice maker w10377151 has been converted to icemaker W10882923 unclear instructions on how to convert