Repair Help

There’s ice build up all around the ice maker assembly and around the auger and bottom part of ice dispenser. Can’t see any damage to the ice maker or water chute. Any suggestions. I had replace the ce maker already and made sure that it was aligned with the water chute

I watches the videos about the ice maker and replacing the ice door seal #da63-06945a and that didn’t work.

some of the lights are flashing.
I turn off the brake and we still have the same issue

Both drain pumps are working properly I have tested them.
All the drain lines are clear .
When I put the machine on it filledls and turns but when it comes to draining I hear the pumps trying to pump the water out but nothing comes out from time to time I hear a grinding sound coming from the back I tilted the machine to try to see what’s going on back there and then I could hear some of the water draining but as soon as I put the machines down the way it should be all I hear is a grinding sound and none of the water comes out

Hello,

When you open bottom oven door the display says bad line then the clock appears then the display goes blank…

ANY INFO YOU MAY HAVE, BUT, DEFINETLY THE SCHEMATIC, ETC.

TX

Hello
I need a service manual for this model.

Thanks

i can not turn the tub by hand
and nothing happens when i turn the unit on.
the timer will display the time for the cycle but that it

GOOD MORNING. I DID NOT CHECK OUT THE UNIT YET, BUT I AM TOLD THAT THE WASHER IS SHOWING THE F07 CODE. ANY INFO WOULD BE GREAT, AS I HAVE NOT SEEN THIS PROBLEM. THANKS, TODD FROM NY.

The Icemaker on this unit will work for a week or so, then it will freeze up with frost and looks like frozen ice cubes all around the icemaker preventing it from operating. When it freezes up, it actually covers the entire ice tray and goes over to the wall of the ice bin. Any help would be appreciated.

NEED WIRING DIAGRAM

The element is not grounded. The relay is not welded closed.

Selected light load, cold wash/cold rinse. Cycle stopped after rinse. Machine went to OFF. Restarted manually at last rinse/spin cycle to get water out; noticed water in washer was very warm. Door locked properly, machine agitated, rinse began but then did not turn off. Shut machine off, water continued to come in from hot water only. Unplugging machine worked; water stopped coming in.

Dishwasher not giving any codes, will fill with water, then circulation motor will not turn on and wash. Homeowner states she smells a burning smell, I didn’t. I can hear the relays on the board clicking and I didn’t see any burnt spots on the board as well. I can’t get the dishwasher out enough to check for power at the motor due to short power wires. Does this sound like a motor issue, or maybe a board?
P.S. —- it will do the cancel and drain as well so I am really thinking motor but not 100%.
Any suggestions or ideas?

This dryer heats even on the air setting and in the diagnostic motor test.

I hear the motor humming trying to run but it will not turn there’s a small smell from the motor.
and I did hear the motor trying to run with out me doing anything