0 votes
7k views

This second ground wire may have connected somewhere – I’am not sure. I went behind panel to check on ice buildup because the ice was melting and refrigerator not cold. Right now the freezer seems fine with the fan working somewhat but no cool air is entering to refrigerator area. I can certainly use your assistance.

  • Michael asked 10 years ago
  • last active 10 years ago
0 votes
3k views

It was working fine, large load was put in, now it will not spin at all.

  • Conrad asked 10 years ago
  • last active 10 years ago
0 votes
3k views

looking for the C Clip that holds the brake cam driver.
I have tried to find it in different appliance stores

  • Raul de Alba asked 10 years ago
  • last active 10 years ago
0 votes
3k views

I have a whirlpool duet model wed9400ve1 that won’t heat. Do you have a video for that specific model on how to test the element and thermostats and then replace failed part? I found some videos but none for this particular model and they seem to really differ, some the elements up front others in back etc.
Thank you

  • Kelly Schuman asked 10 years ago
  • last active 10 years ago
0 votes
2k views
  • carlos asked 10 years ago
  • last active 10 years ago
0 votes
31k views

Hi, I watched your video on the clogged washer and got as far as taking the dasher out but we can’t get the tub to come out. Do you have any suggestions?

  • Linda Hughes asked 10 years ago
  • last active 10 years ago
0 votes
3k views

I just used my dryer yesterday and it worked fine, but today I went to get the load out and it was still damp. Doesn’t seem to be blowing any hot air out. What do you think the problem could be?

  • Dennis Jones asked 10 years ago
  • last active 10 years ago
0 votes
7k views

Hi, I wanted to find out how to replace the element in my oven? It cracked and broke in half while I was using it and my neighbor said I could probably handle replacing it myself. Would you advise this? I’m not sure if it’s something I could do or not. Any help would be appreciated!

  • Andrea asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Just my fridge side is not cooling. I had a friend take a look and he is pretty sure it’s the control. I’d like to have my husband take care of this but didn’t see any videos listed for my model number and figured you might be able to point me in the right direction.

  • Grace H. asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Hi, We have ice that builds up in the bottom of the freezer in our Kenmore Cold Spot side-by-side refrigerator/freezer. I break it up and clean it out and within a couple days, it’s back. I’m not sure what is causing it or how to fix it. I’ve seen many posts online but none are specific to my model….just want to make sure we do the right thing to fix it. Thanks in advance for any guidance you can give me.

Amy

  • Amy Geiger asked 10 years ago
  • last active 10 years ago
0 votes
2k views

vegtables freeze in the back of refrigarator section

  • george perry asked 10 years ago
  • last active 10 years ago
0 votes
6k views

Have an FE error …emptied out at the bottom but I know the hose is clogged. Have the top off and found the other end. Any suggestions how to clear the clog out of the hose?

  • Susan asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Machine makes a lot noise like the machine is coming apart. I think it might be the suspension rods, but they are not broken.

  • Dom asked 10 years ago
  • last active 10 years ago
0 votes
3k views

My sister has the same bottom freezer refrigerator, purchased 2 yrs later, as mine. Mine developed a problem with defrosting water onto the floor. It needed to have a rubber grommet replaced by a drain tube. Does her newer model also need this upgrade?
(It has not leaked onto the floor as yet, but it is only lightly used so that could be why.)

Thank you!

  • Carole Simmons asked 10 years ago
  • last active 10 years ago
0 votes
2k views

The pressure regulator is marked for lp as well as nat.gas. Is this regulator built to be able to change from one to the other?

  • Jerry Goehring asked 10 years ago
  • last active 10 years ago
0 votes
5k views

The fridge is leaking water into the bottom drawer and it is not cooling. I saw the video Samsung RF268ABBP Refrigerator Repair – Fresh food section is leaking water – Sensor. This is the closest to the model I have. Also another one I saw similar is Samsung RF266AEPN Refrigerator Repair – Not cooling properly, freezing up on the back panel – Evaporator and Defrost System. Am I better off trying to replace the sensor or the whole Evaporator and defrost system on my Samsung RF267AERS ?

Thanks in advance for your answer!

  • Richard Sam asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Everything works except there is NO agitation during wash or rinse cycle. Washes, drains and spins fine

  • Thomas asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Upon start up, water begins to enter washer. Blinking lid lock light, stops machine from running. I replaced the switch and have the same problem.

  • Steve Winters asked 10 years ago
  • last active 10 years ago
0 votes
3k views

Fisher Paykel DEGX2US Top-Load Dryers continues to dry, won’t shut off! Yet 20 and 40 minute setting will time out.Problem started after dryer quit drying, found full of lint, cleaned and reset thermostat.. Resumed use,until realized it wouldn’t stop drying!

  • Steve Farney asked 10 years ago
  • last active 10 years ago
0 votes
2k views

at first if you pushed hard it would work but not now, only way i can use it is change cycle!

would it be the input or the processor ?

  • Guest asked 10 years ago
  • last active 10 years ago
0 votes
26k views

I repaired the drain pump on my dishwasher. Now I can’t get it to start.

  • Paul Bergstrom asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Machine is 27 years old but has run fine until now. I’ve replaced the coils and checked for continuity on high end thermostat and the cycling thermostat. Blower is working fine and we do not have a vent obstruction. Dryer starts normally, igniter heats up and flame runs about 8 seconds. Igniter cycles intermitantly but with the same short burn time. Timer does not advance in dry cycles but does work in “less dry” period at the end of a cycle. I’m thinking the burner shutting off prematurely is causing the timer not to advance, but I’m at a loss as to why that is.

  • fred mayo asked 10 years ago
  • last active 10 years ago
0 votes
3k views

I would like to know how to put this freezer into the defrost cycle. it was frosted up, so i took it apart and defrosted it. the heater was ok. the defrost thermostat read open even frozen in the ice. after I jiggled the wires a little then it showed good. I replaced it anyway. I would like to put an amp clamp on it while its cold and kick it into defrost to make sure its fixed. i know some of them you open the door a couple of times. I would like to know the sequence to put this one in defrost .

  • ralph harkins asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Have unplugged unit for long periods 2 hours or more trying to reset any faults , see no faults , plugged back in this last time and lock out light came on . cannot clear it with end of cycle button , and will not let any buttons work . Display blank.
First few times I could unplug for about an hour and re connect and it would come on and dry to end of cycle . But while drying you could not pause or cancel drying. opening door would stop it however.
Is it interface board or control board ?
Thanks ;
Steve

  • Steve Smallwood asked 10 years ago
  • last active 10 years ago
0 votes
2k views

it just happened one day with no prior problems. only the cancel light will illuminate when pressed. tried turning off power for over 12 hours still the same. then after a week it worked as normal just once now back to just the cancel.

  • larry asked 10 years ago
  • last active 10 years ago
0 votes
2k views

Hi,

We have a over the counter microwave and I have already replace the door fuse all 3, each of the fuse has fix the same problem every time and this last time (4th) not sure what will it take.
Here is the problem: If we leave the door close there a noise like if the micro is on but the plate is not turning around the light will be of but if i leave a cap of water it will heat it up, but if I put time it will work like is fine with light on and plate rotating till the time end.
the fuses have a normal click when you push them on, I’m not sure if it will be the master control which is about the same price as a new micro.
I search on your site for parts but nothing show up, is a Frigidaire FMV152KSA serial KG93202752.
I was looking on your videos on the tube.
Let me know if you have parts need it for repair.

Thank you

  • Martin asked 10 years ago
  • last active 10 years ago
0 votes
2k views

when I turn on the stove it show me error f 7 and f 9. it don’t let me do nothing. It don’t let me press bake. when i clear those number it come back again. I can not used the oven. I don’t have problem with the top. what i need to do? do i need to reset?

  • sonia roldan asked 10 years ago
  • last active 10 years ago
0 votes
2k views

My lg french door fridge doesnt make ice anymore and the freezer wont freeze either. Im sure its the same problem for both malfunctions. I have a pull out freezer on bottom. What can it be? The freezer is just cold not freezing and i do have water forbthe ice machine just not getting cold what can be the problem?

  • cesar asked 10 years ago
  • last active 10 years ago
0 votes
2k views

How do I check if it is good

  • john asked 10 years ago
  • last active 10 years ago
0 votes
7k views

SAMSUNG RS265 TDWP/XAA – purchased in 2012 .

Problems: no cooling air on the fridge compartment, but freezer has working normally.
The problem details:
o Water drained into and frosted under the vegetable bottom drawer for a couple weeks, stopped.
o Noise from fan was on and off in the following weeks and stopped.
o Now, no more cooling in the fridge compartment.
o I watched the VA video. Do you think the Evaporator Defrost system/heater, sensor, or the main board is needed for my refrigerator? What is the part number I should order on VA website?

I’d like to thank for your help.

  • Linda Bach asked 10 years ago
  • last active 10 years ago
Showing 61 - 90 of 9k results