Repair Help

On this dryer the thermal fuse keeps going out, after it runs for awhile? What causes this problem? The vent is clear and is a short vent run.
If this keeps going out should you also replace the thermostats where is down by the heater, or should I look at the thermistor might be bad?

the unit says vacuum condenser.
however the middle section of the back wall is over flowing with Frost.

So when the washer reaches its top speed you start to hear a loud noise the shock obserber was replaced and it still does the same thing. Can you please help?

ORIGINAL COMPAINT WAS A WATER LEAK FROM BEHIND THE ICE DISPENCER HOLE. NOT FROM WATER DISPENCER TUBE. TURNING OFF WATER SUPPLY CURED LEAK, SO NOT ICE MELTING. THE SLOW DRIP IS COMING DOWN THE BACK SURFACE AREA WHERE YOU PLACE YOUR GLASS.

SEPERATE ISSUE: CUSTOMER WAS USING THE ICE DISPENCER AND MAY HAVE BEEN FILLING THE HOPPER WITH BAGGED ICE (NOT SURE. MAY HAVE BEEN LEFTOVER ICE FROM ICE MAKER). WHILE DISPENCING ICE A CHUNK OF PLASTIC DROPPED INTO HER GLASS. IT APPEARS TO BE SOME SORT OF ARM/LEVER? NOW THE ICE MAKER WILL ONLY DISPENCE CRUSHED ICE. I THINK IT IS PART OF THE ICE CRUSH MOTOR ASSY BUT I COULD NOT SEE WHERE IT CAME FROM. LINKAGE ON THE TUB MOVES THE FLAP IN THE ASSY BUT IT HANGS A LITTLE.

THANKS, GEORGE.

Customer said no matter what size load the washer goes out of balance. She stops washer redistributes the load and after a little it is out of balance. I am not that familiar with Samsung washers. I did check the suspension rods and balance ring both are o.k.. Has there been a recall on this. The washer is about 18months old. Any help would be greatly appreciated.

       Customer complain is that when dryer is in any cycle but timed that the time remaining is wrong. Example 10 minutes remaining will be 25-30 minutes in real time.  Also on timed cycle that the clothes in her opinion come out to hot. She has to take them out right after cycle stops, to keep them from being wrinkled.  Thanks Ricky

I will not turn on.
wehn I press the buttons the lights flash but will start

the lid is closed but i am still getting the LO error

The refrigerator works perfect, except about every hour I get a 1 minute buzz for the evaporator fan motor then it stops and blows normal. Whirlpool Refrigerator

Good Evening Matt, do you have the service manual for this unit. Has an e84 error code, customer states they hear a pop noise before the code displays.

Thanks

REFRIGERATOR IS LEAKING WATER FROM INSIDE AT THE TOP SELF. ATTEMPT TO OPEN THE FREEZER COVER WE FOUND FROZEN ICE WATER INSIDE THE WALL OF THE FREEZER , WE DEFROSTED AND CLEANED THE ICE BUT IT STILL LEAKING THE SAME . COULD YOU PLEASE TELL ME IF WE NEED TO CHANGE ANY PART TO SOLVE THE PROBLEM.