Repair Help

Samsung Dryer no heat stays in cooling mode
What is wrong with it?

Refrigerator it doesn’t cooling very well. The compressor is running, the condenser fan is turning , the evaporator fan is turning, the pressure in the system is fine. What could be the problem with this refrigerator?. Do you think is with the refrigerator thermistor . How can I put this refrigerator into test mode. Thanks.

(Couldn’t find model. Googled simular looking one.) Griddle uses an electrode to light but when you turn on the thermostat/pot control it doesn’t do anything I didn’t even smell or hear gas. There’s what appears to be a spark module under it which the electrode is connected to.. Would it most likely be that spark module? Other things factors could be a bad thermostat or gas valve.

Customer complaint is that it’s been throwing unbalanced errors. They will go on to readjust load but that does not help. All they can do at the point is drain the water.

Looking for any suggestions

error code 03

CUSTOMER COMPLAINS DISHES WET AT THE END OF CYCLE (NOT DRYING)

I’ve checked evaporator coil for ice buildup. No ice, fan is working, freezer thermostat has continuity , freezer thermistor good, door seal in good shape and clean, no gaps, condenser is running but hot to touch, relay isn’t clicking, no unusual noises, door controller reading”high temperature” ,set on lowest setting #7 temperature is 23. Any ideas?

I replace control board wpw10284942 and oven sensor. i was thinking of replacing wp74008369 board because the power goes from there i think.

This is the first time we are seeing this refrigerator. It has a feature known as “AutoFill”. You place a cup or container on the water/ice dispenser platform and the fridge automatically fills the container to the appropriate level. This particular fridge keeps displaying “No container” when you place a cup and hit autofill. I tried researching this and found that it is sometimes the result of a non-uniform container. Our technicians tried several container types that were uniform and still received the same error message. All other functions of the refrigerator are working fine.

Pease tell me which color wire goes on which connector.

Water is leaking from ice maker in fresh food section, the cube seem to be melting slightly after production.

Washer won’t run the final spin cycle, it works but stops before the final spin cycle

Try to open freezer. Cannot see if anything wedged or door problem.

Dishwasher wasn’t working.
Tested for 120v to dishwasher. Ok
Pulled power plug from control board. Nothing

Losing power between electrical connection and control board. Looks like a possible transformer wire harness between the two.

Suggestions on what to test?

How do I access all the components to fix magnetron diode fan capacitor and HV CAPACITOR.

Hello,

I’m having difficulty disassembling a GE dryer model number GFDS170EHWW. Do you have any videos or instructions for this model? I’ve removed all visible screws and I thought it just slid back.

Hello, I am working on a L.G. French door refrigerator. Condesor fan runs. Compressor does not start. The controller board that operates the compressor has a green light that flashes. I feel the control board is bad, my question is could a thermistor or any other input cause this situation.

I have a Kenmore washer that will not remove the water from clothes in final, I have to give a second spin cycle. I have also noticed a moldy smell coming from the washer lately, what should I be looking for in the way of a repair.